10PH SINGLE-PHASE FULL WAVE BRIDGE 10 AMPERES FOR P.C. BOARD AND HEAT SINK MOUNTING INTEGRALLY MOLDED HEAT SINK PROVIDES LOW THERMAL RESISTANCE SPACE SAVING IN-LINE DESIGN This product has recognition under the components program of Underwriters Laboratories, inc. PRV/Leg 50V 100V 200V 400V 600V 800V 1000V Type No. 10PH05 10PH10 10PH20 10PH40 10PH60 10PH80 10PH100 ELECTRICAL CHARACTERISTICS PER LEG (at TA =25 C Unl es s Oth erw ise Spe ci fie d) Average Output Current, IO@65 oC TC (Fig.1) 10 Amp Max.Forward Voltage Drop, VF=1.0 V 2.5 Amp @ I F= 10 A Max. D C Reverse Current @ PRV and 100 o C, I R 300 A Max. Peak Surge Current, IFSM(8.3 ms) (Fig.2) 300 Amp Max. DC Reverse Current @ PRV, I R Thermal Resistance, R0- j-c 4.5Typ. o C/ W Ambient Operating Temperature Range, TA -55 to +150 o Storage Temperature Range, TSTG -55 to +150 o C C Note 1: Derate Io by 20% for capacitive loads EDI reserves the right to change these specifications at any time without notice 10PH FIG.2 NON-REPETITIVE SURGE CURRENT FIG.1 CURRENT DERATING 1000 65 10 O TC 500 HEAT SINK MOUNTING MAX.PEAK SURGE CURRENT I FSM lO.AVERAGE L FORWARD CURRENT(AMP) 12 8 200 65 6 O 100 TL PC BOARD MOUNTING WITH 3/8 LEADS 4 BRIDGE OUTPUT RES.-IND. LOADS 2 Derate current by 20% for capacitive loads 50 20 10 0 0 25 75 50 100 125 1 150 5 2 10 20 50 100 NUMBER OF CYCLES AT 60 CPS O TEMPERATURE ( C) Dielectric test voltage 2500 volts rms, Max. 50-60Hz CASE STYLE FOR 10PH .160 .140 .935 .895 .280 .260 .185 .165 .085 .065 .700 .660 .760Max. INTEGRAL HEAT SINK .455 .405 .075R.Typ. (2 Places) 1.0Min .260 .180 .220 .180 NOTE .205 .185 .052 .048 Maximum lead and terminal temperature for soldering, 3/8 inch from case 5 seconds at 250 C ELECTRONIC DEVICES, INC. DESIGNERS AND MANUFACTURERS OF SOLID STATE DEVICES SINCE 1951. 21 GRAY OAKS AVENUE * YONKERS. NEW YORK 10710 914-965-4400 Ee-mail:[email protected] *Wwebsite: http://www.edidiodes.com * FAX 914-965-5531 * 1-800-678-0828