6PH SINGLE-PHASE FULL WAVE BRIDGE 6 AMPERES FOR P.C. BOARD AND HEAT SINK MOUNTING mponent under the co n o iti n g co dicates re s, inc. This mark in derwriters Laboratorie n U f o program PRV/Leg Type No. 50V 6PH05 100V 200V 400V 600V 800V 1000V 6PH10 6PH20 6PH40 6PH60 6PH80 6PH100 ELECTRICAL CHARACTERISTICS PER LEG (at TA =25 C Unless Otherwise Specified) 6 Amp Max.Forward Voitage Drop,VF=1.0V @ IF = 2.5 Amp Max.DC Reverse Current @ PRV, and 25 C , IR 10 A Max.DC Reverse Current, @ PRV and 100 C , IR 300 A Max.Perk Surge Current, I FSM (8.3ms) (Fig.2) 250 Amp O Average Output Current, lo @ 65 C Tc (Fig.1) Ambient Operating Temperature Range,TA -55 to +150 Storage Temperature Range,TSTG -55 to +150 o C o C Note 1: Derate IO by 20% for capacitive loads EDI reserves the right to change these specifications at any time without notice. 6PH FIG.2 NON-REPETITIVE SURGE CURRENT FIG.1 CURRENT DERATING 6 1000 O TC 500 5 HEAT SINK MOUNTING 65 TL O 4 PC BOARD MOUNTING WITH 3/8" LEADS 3 2 BRIDGE OUTPUT RES.-IND. LOADS 1 Derate current by 20% for capacitive loads MAX.PEAK SURGE CURRENT IFSM lO.AVERAGE L FORWARD CURRENT(AMP) 65 200 100 50 20 10 0 0 25 75 50 100 125 150 1 5 2 10 20 50 100 NUMBER OF CYCLES AT 60 CPS O TEMPERATURE ( C) FIG.3 CASE STYLE FOR 6PH .935 .895 .160 .140 .280 .260 .185 .165 45 .700 .660 .760Max. .075R.Typ. (2 Places) 1.0Min. .085 .065 .455 .405 .260 .180 .220 .180 .205 .185 .052 .048 Dielectric test voltage 2,500 V rms., Max. 50-60Hz NOTE Maximum lead and terminal temperature for soldering, 3/8 inch from case, 5 seconds at 250 C ELECTRONIC DEVICES, INC. DESIGNERS AND MANUFACTURERS OF SOLID STATE DEVICES SINCE 1951. 21 GRAY OAKS AVENUE * YONKERS. NEW YORK 10710 914-965-4400 Ee-mail:[email protected] Wwebsite: http://www.edidiodes.com * * FAX 914-965-5531 * 1-800-678-0828