11mm x 1.4mm BACKLIGHT ATTENTION OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DISCHARGE SENSITIVE DEVICES Features AA1114/2MBC/CC BLUE Description LOW POWER CONSUMPTION. The Blue source color devices are made with GaN on SiC IDEAL FOR BACKLIGHTING. Light Emitting Diode. RoHS COMPLIANT. Static electricity and surge damage the LEDS. It is recommended to use a wrist band or anti-electrostatic glove when handling the LEDs. All devices, equipment and machinery must be electrically grounded. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAB2775 REV NO: V.3 DATE: APR/21/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1201000010 Selection Guide Part No. Dice AA1114/2MBC/CC Iv (mcd) @ 20mA Lens Type BLUE (GaN) WATER CLEAR Viewing Angle Min. Typ. 2θ θ1/2 4 10 120° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Blue λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 430 nm IF=20mA Blue 466 nm IF=20mA Spectral Line Half-width Blue 60 nm IF=20mA C Capacitance Blue 100 pF VF=0V;f=1MHz VF Forward Voltage Blue 3.8 4.5 V IF=20mA IR Reverse Current Blue 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Blue Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 150 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAB2775 REV NO: V.3 DATE: APR/21/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1201000010 Blue AA1114/2MBC/CC SPEC NO: DSAB2775 REV NO: V.3 DATE: APR/21/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1201000010 PACKING & LABEL SPECIFICATIONS AA1114/2MBC/CC Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAB2775 REV NO: V.3 DATE: APR/21/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1201000010