SUBMINIATURE SOLID STATE LAMP AM2520ID03 HIGH EFFICIENCY RED Description Features SUBMINIA TURE PACKAGE. The High Efficiency Red source color devices are made with WIDE VIEWING ANGLE. Gallium Arsenide Phosphide on Gallium Phosphide Orange GULL WING LEAD. Light Emitting Diode. LONG LIFE - SOLID STATE RELIABILITY. LOW PACKAGE PROFILE. PACKAGE : 1000PCS / REEL. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAD1253 REV NO: V.3 DATE: APR/05/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1202000478 Selection Guide Part No. Dice AM2520ID03 Iv (mcd) @ 20mA Lens Type HIGH EFFICIENCY RED (GaAsP/GaP) Viewing Angle Min. Typ. 2 θ 1/2 7 30 40° RED DIFFUSED Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Units Test Conditions λpeak Peak Wavelength High Efficiency Red Device Typ. 627 Max. nm IF=20mA λD Dominant Wavelength High Efficiency Red 625 nm IF=20mA ∆λ1/2 Spectral Line Half-width High Efficiency Red 45 nm IF=20mA C Capacitance High Efficiency Red 15 pF VF=0V;f=1MHz VF Forward Voltage High Efficiency Red 2.0 2.5 V IF=20mA IR Reverse Current High Efficiency Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter High Efficiency Red Units 105 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Power dissipation Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD1253 REV NO: V.3 DATE: APR/05/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1202000478 High Efficiency Red AM2520ID03 SPEC NO: DSAD1253 REV NO: V.3 DATE: APR/05/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1202000478 AM2520ID03 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAD1253 REV NO: V.3 DATE: APR/05/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1202000478