SUBMINIATURE SOLID STATE LAMP AM27ID09 HIGH EFFICIENCY RED Description Features The High Efficiency Red source color devices are SUBMINIATURE PACKAGE. made with Gallium Arsenide Phosphide on Gallium WIDE VIEWING ANGLE. Phosphide Orange Light Emitting Diode. Z-BEND LEAD. LONG LIFE - SOLID STATE RELIABILITY. LOW PACKAGE PROFILE. PACKAGE :1000PCS / REEL. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAD1324 REV NO: V.4 APPROVED: J. Lu CHECKED: Allen Liu DATE: MAR/05/2005 DRAWN: W.J.ZHU PAGE: 1 OF 4 ERP:1202000265 Selection Guide Part No. Dice AM27ID09 Iv (mcd) @ 20mA Lens Type Viewing Angle Min. Typ. 2θ θ1/2 7 30 40° HIGH EFFICIENCY RED (GaAsP/GaP) RED DIFFUSED Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength High Efficiency Red λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 627 nm IF=20mA High Efficiency Red 625 nm IF=20mA Spectral Line Half-width High Efficiency Red 45 nm IF=20mA C Capacitance High Efficiency Red 15 pF VF=0V;f=1MHz VF Forward Voltage High Efficiency Red 2.0 2.5 V IF=20mA IR Reverse Current High Efficiency Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter High Efficiency Red Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD1324 REV NO: V.4 APPROVED: J. Lu CHECKED: Allen Liu DATE: MAR/05/2005 DRAWN: W.J.ZHU PAGE: 2 OF 4 ERP:1202000265 High Efficiency Red AM27ID09 SPEC NO: DSAD1324 REV NO: V.4 APPROVED: J. Lu CHECKED: Allen Liu DATE: MAR/05/2005 DRAWN: W.J.ZHU PAGE: 3 OF 4 ERP:1202000265 AM27ID09 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength),the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAD1324 REV NO: V.4 APPROVED: J. Lu CHECKED: Allen Liu DATE: MAR/05/2005 DRAWN: W.J.ZHU PAGE: 4 OF 4 ERP:1202000265