SUBMINIATURE SOLID STATE LAMP AM2520ID09 HIGH EFFICIENCY RED Features Description OWIDE VIEWING ANGLE. The High Efficiency Red source color devices are made with OSUBMINIATURE PACKAGE. Gallium Arsenide Phosphide on Gallium Phosphide Orange OZ-BEND LEAD. OLONG LIFE - SOLID STATE RELIABILITY. Light Emitting Diode. OLOW PACKAGE PROFILE. OPACKAGE : 1000PCS / REEL. z RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAD1279 APPROVED: J. Lu REV NO: V.3 CHECKED: Allen Liu DATE: APR/05/2005 DRAWN: S.H.CHEN PAGE: 1 OF 4 ERP:1202000482 Selection Guide Part No. Dice AM2520ID09 Iv (mcd) @ 20mA Lens Type HIGH EFFICIENCY RED (GaAsP/GaP) Viewing Angle Min. Typ. 2 θ 1/2 7 30 40° RED DIFFUSED Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength High Efficiency Red λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 627 nm IF=20mA High Efficiency Red 625 nm IF=20mA Spectral Line Half-width High Efficiency Red 45 nm IF=20mA C Capacitance High Efficiency Red 15 pF VF=0V;f=1MHz VF Forward Voltage High Efficiency Red 2.0 2.5 V IF=20mA IR Reverse Current High Efficiency Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter High Efficiency Red Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD1279 APPROVED: J. Lu REV NO: V.3 CHECKED: Allen Liu DATE: APR/05/2005 DRAWN: S.H.CHEN PAGE: 2 OF 4 ERP:1202000482 High Efficiency Red SPEC NO: DSAD1279 APPROVED: J. Lu AM2520ID09 REV NO: V.3 CHECKED: Allen Liu DATE: APR/05/2005 DRAWN: S.H.CHEN PAGE: 3 OF 4 ERP:1202000482 AM2520ID09 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAD1279 APPROVED: J. Lu REV NO: V.3 CHECKED: Allen Liu DATE: APR/05/2005 DRAWN: S.H.CHEN PAGE: 4 OF 4 ERP:1202000482