SUBMINIATURE SOLID STATE LAMP AM27SYC08 SUPER BRIGHT YELLOW Features Description OWIDE VIEWING ANGLE. The Super Bright Yellow device is made with DH InGaAlP OSUBMINIATURE PACKAGE. (on GaAs substrate) light emitting diode chip. OYOKE LEAD. OLONG LIFE-SOLID STATE RELIABILITY. OLOW PACKAGE PROFILE. OPACKAGE : 1000PCS / REEL. ORoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the lead emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAD1318 REV NO: V.2 APPROVED: J. Lu CHECKED: Allen Liu DATE: MAR/10/2005 DRAWN: S.H.CHEN PAGE: 1 OF 4 ERP:1202000408 Selection Guide Part No. Dice AM27SYC08 Iv (mcd) @ 20mA Lens Type SUPER BRIGHT YELLOW (InGaAIP) WATER CLEAR Viewing Angle Min. Typ. 2θ1/2 110 700 20° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength Super Bright Yellow λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 590 nm IF=20mA Super Bright Yellow 588 nm IF=20mA Spectral Line Half-width Super Bright Yellow 28 nm IF=20mA C Capacitance Super Bright Yellow 25 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Yellow 2.0 2.5 V IF=20mA IR Reverse Current Super Bright Yellow 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Yellow Units Power dissipation 125 mW DC Forward Current 30 mA Peak Forward Current [1] 150 mA 5 V Reverse Voltage -40°C To +85°C Operating/Storage Temperature Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD1318 REV NO: V.2 APPROVED: J. Lu CHECKED: Allen Liu DATE: MAR/10/2005 DRAWN: S.H.CHEN PAGE: 2 OF 4 ERP:1202000408 Super Bright Yellow AM27SYC08 SPEC NO: DSAD1318 REV NO: V.2 APPROVED: J. Lu CHECKED: Allen Liu DATE: MAR/10/2005 DRAWN: S.H.CHEN PAGE: 3 OF 4 ERP:1202000408 AM27SYC08 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength), the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAD1318 REV NO: V.2 APPROVED: J. Lu CHECKED: Allen Liu DATE: MAR/10/2005 DRAWN: S.H.CHEN PAGE: 4 OF 4 ERP:1202000408