3.0x2.0mm SMD CHIP LED LAMP KPK-3020SURC Features HYPER RED Description !3.0mmX2.0mm SMT LED, 1.3mm THICKNESS. !LOW POWER CONSUMPTION. InGaAlP on GaAs substrate Light Emitting Diode. !WIDE VIEWING ANGLE. !IDEAL The Hyper Red source color devices are made with DH FOR BACKLIGHT AND INDICATOR. ! VARIOUS COLORS AND LENS TYPES AVAILABLE. !PACKAGE:2000PCS/REEL Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.2(0.0079") unless otherwise noted. 3. Specifications are subject to change without notice. SPEC NO: DSAA9196 APPROVED : J. Lu REV NO: V.2 CHECKED :Allen Liu DATE: DEC/16/2002 DRAWN:S.J.HOU PAGE: 1 OF 4 Selection Guide P ar t N o . Dic e KPK-3020SURC Iv (m c d ) @ 20 m A L en s Ty p e HYPER RED ( InGaAIP) WATER CLEAR V i ew i n g An g l e Min . Ty p . 2θ1/2 70 230 120° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°°C Sy m b o l P ar am et er D ev i c e λpeak Peak Wavelength Hyper Red λD Dominate Wavelength ∆λ1/2 Ty p . Max . Un its Tes t Co n d it io n s 640 nm I F =20mA Hyper Red 628 nm I F =20mA Spectral Line Half-width Hyper Red 27 nm I F =20mA C Capacitance Hyper Red 45 pF VF =0V;f=1MHz VF Forward Voltage Hyper Red 1.9 2.5 V I F =20mA IR Reverse Current Hyper Red 10 uA V R = 5V Absolute Maximum Ratings at TA=25°°C P ar am et er H y p er R ed Un its Power dissipation 170 mW DC Forward Current 30 mA Peak Forward Current [1] 185 mA Reverse Voltage 5 V Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAA9196 APPROVED : J. Lu REV NO: V.2 CHECKED :Allen Liu DATE: DEC/16/2002 DRAWN:S.J.HOU PAGE: 2 OF 4 Hyper Red SPEC NO: DSAA9196 APPROVED : J. Lu KPK-3020SURC REV NO: V.2 CHECKED :Allen Liu DATE: DEC/16/2002 DRAWN:S.J.HOU PAGE: 3 OF 4 KPK-3020SURC SMT Reflow Soldering Instructions Number of reflow process shall be less than 2 times and cooling process to normal temperature is required between first and second soldering process. Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) SPEC NO: DSAA9196 APPROVED : J. Lu REV NO: V.2 CHECKED :Allen Liu DATE: DEC/16/2002 DRAWN:S.J.HOU PAGE: 4 OF 4