T-1 3/4 (5mm) SOLID STATE LAMP ATTENTION WP7113MBD BLUE OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DISCHARGE SENSITIVE DEVICES Description Features LOW POWER CONSUMPTION. The Blue source color devices are made with GaN on SiC POPULAR T-1 3/4 DIAMETER PACKAGE. Light Emitting Diode. GENERAL PURPOSE LEADS. Static electricity and surge damage the LEDS. RELIABLE AND RUGGED. It is recommended to use a wrist band or LONG LIFE - SOLID STATE RELIABILITY. anti-electrostatic glove when handling the LEDs. AVAILABLE ON TAPE AND REEL. All devices, equipment and machinery must be electrically RoHS COMPLIANT. grounded. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAF2410 REV NO: V.1 DATE: APR/19/2005 PAGE: 1 OF4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101005103 Selection Guide Part No. Dice WP7113MBD Iv (mcd) @ 20 mA Lens Type BLUE (GaN) BLUE DIFFUSED Viewing Angle Min. Typ. 2θ θ1/2 36 60 20° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Blue λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 430 nm IF=20mA Blue 466 nm IF=20mA Spectral Line Half-width Blue 60 nm IF=20mA C Capacitance Blue 100 pF VF=0V;f=1MHz VF Forward Voltage Blue 3.8 4.5 V IF=20mA IR Reverse Current Blue 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Blue Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 150 mA 5 V Reverse Voltage Operating / Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAF2410 REV NO: V.1 DATE: APR/19/2005 PAGE: 2 OF4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101005103 Blue WP7113MBD SPEC NO: DSAF2410 REV NO: V.1 DATE: APR/19/2005 PAGE: 3 OF4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101005103 PACKING & LABEL SPECIFICATIONS WP7113MBD Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF2410 REV NO: V.1 DATE: APR/19/2005 PAGE: 4 OF4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101005103