L, S BAND SPDT GaAs MMIC SWITCH FEATURES UPG152TA INTERNAL BLOCK DIAGRAM • WIDE FREQUENCY RANGE: 100 MHz to 2.5 GHz • LOW INSERTION LOSS: 0.5 dB Typical at 2.0 GHz • HIGH P1dB: +30 dBm typ. @ 2 GHz OUT 2 3 4 VCONT2 GND 2 5 IN OUT 1 1 6 VCONT1 • LOW CONTROL VOLTAGE: +3V or 0V • SUPER SMALL SURFACE MOUNT PACKAGE: SOT-26 • AVAILABLE ON TAPE AND REEL DESCRIPTION The UPG152TA is an L-Band Single Pole Double Throw (SPDT) GaAs MMIC switch developed for digital cellular, cordless, and PCS handset, WLAN, and other RF control applications. The device features low insertion loss, high P1dB, and low voltage operation. It is housed in a super small, lowcost SOT-26 package and is also available on tape-and-reel. NEC's stringent quality assurance and test procedures ensure the highest reliability and performance. ELECTRICAL CHARACTERISTICS (TA = 25°C, VCONT = 3V/0V) PART NUMBER PACKAGE OUTLINE SYMBOLS IL PARAMETERS AND CONDITIONS UPG152TA T06 UNITS MIN Insertion Loss f = 0.1 – 2 GHz f = 2.0 – 2.5 GHz dB dB ISOL Isolation f = 0.1 – 2 GHz f = 2.0 – 2.5 GHz dB dB 20 RLIN Input Return Loss f = 0.1 - 2 GHz dB 11 Output Return Loss f = 0.1 - 2 GHz dB 11 dBm 27 RLOUT P1dB Input Power at 1 dB Compression f = 0.1 - 2 GHz IIP3 Input IP3 at f = 900 MHz, VCONT = +3 V f = 1900 MHz, VCONT = +3 V tSW Switching Speed Control Current ICONT TYP MAX 0.5 0.8 1.0 22 20 30 dBm dBm +48 +44 f = 0.1 - 2 GHz ns 30 f = 0.1 - 2 GHz, VCONT = 3V/0V, no RF signal µA 5 California Eastern Laboratories UPG152TA ABSOLUTE MAXIMUM RATINGS1 (TA = 25°C) SYMBOLS VCONT 1,2 PARAMETERS UNITS Control Voltage 1 and 2 RATINGS UPG152TA V -6.0 to +6.0 2.7≤|VCONT1-VCONT2|≤6.0V PIN Input Power dBm 31 PTOT Total Power Dissipation W 0.4 TOPT Operating Case Temperature °C -50 to +90 TSTG Storage Temperature °C -65 to +150 Note: 1. Operation in excess of any one of these parameters may result in permanent damage. RECOMMENDED OPERATING CONDITIONS UPG152TA SYMBOL PARAMETER VCONT Control Voltage (ON) VCONT Control Voltage (OFF) PIN Input Power Level (VCONT = 3V/0V) UNITS MIN TYP MAX V +2.7 +3.0 +5.3 V -0.2 0 +0.2 +27 +29 dBm APPLICATION EXAMPLE (PCS Handset) RX DEMOD ÷N SW I Q PLL UPG152TA PLL UPC8105GR 0˚ TX I Phase Shifter 90˚ PA UPC8106T Q UPG152TA TEST CIRCUIT UPG152TA IN Zo = 50Ω 51pF VCONT2 = 0V/3V VCONT1 = +3V/0V 1000pF 4 6 1000pF G1B 3 51pF 1 51pF OUT 2 OUT 1 Zo = 50Ω SWITCH LOGIC TABLE CONTROL INPUTS (V) CONDITION OF OUTPUT PORTS1 VCONT1 VCONT2 OUT1 OUT2 0 0 OFF OFF OFF 0 +3 ON +3 0 OFF ON +3 +3 OFF OFF Note: 1. Impedance of the output port in the "OFF" state is reflective. Zo = 50Ω UPG152TA PIN CONNECTION DIAGRAM CONNECTION 1 OUT 1 2 GND 3 OUT 2 4 VCONT2 5 IN 6 VCONT1 OUTLINE DIMENSIONS (Units in mm) 3 2 Top View G1B PIN NO. 1 4 4 5 5 2 6 6 1 ORDERING INFORMATION PART NUMBER UPG152TA PACKAGE OUTLINE T06 Bottom View UPG152TA-E3 QTY 3000/Reel +0.2 2.8 -0.3 +0.2 1.5 -0.1 3 0.95 1.9±0.2 2 0.95 4 G1B 2.9±0.2 5 1 +0.2 1.1 -0.1 6 -0.05 0.3 +0.10 0.13±0.1 0.8 0 to 0.1 All dimensions are typical unless otherwise specified. Life Support Applications These NEC products are not intended for use in life support devices, appliances, or systems where the malfunction of these products can reasonably be expected to result in personal injury. The customers of CEL using or selling these products for use in such applications do so at their own risk and agree to fully indemnify CEL for all damages resulting from such improper use or sale. EXCLUSIVE NORTH AMERICAN AGENT FOR NEC RF, MICROWAVE & OPTOELECTRONIC SEMICONDUCTORS CALIFORNIA EASTERN LABORATORIES • Headquarters • 4590 Patrick Henry Drive • Santa Clara, CA 95054-1817 • (408) 988-3500 • Telex 34-6393 • FAX (408) 988-0279 Internet: http://WWW.CEL.COM DATA SUBJECT TO CHANGE WITHOUT NOTICE 12/7/2001 3