HIGH–FREQ ALUMINUM ELECTROLYTIC HD SERIES SUBMINIATURE (Radial Lead, Horizontal Deflection) MECHANICAL SPECIFICATIONS Lead Solderability: The NTE HD series of aluminum electrolytic non–polarized capacitors are designed specifically for horizontal deflection current correction where high frequency and high ripple current occur. Meets the requirements of MIL–STD 202, Method 208 Marking: Consists of series type, nominal capacitance, rated voltage, temperature range, anode and/or cathode identification, NTE identification. RATINGS Capacitance Range: 1.0µf to 10µf Recommended Cleaning Solvents: Tolerance: ±20% Methanol, isopropanol ethanol, isobutanol, petroleum ether, propanol and/or commercial detergents. Halogenated hydrocarbon cleaning agents such as Freon (MF, TF, or TC), trichloroethylene, trichloroethane, or methylchloride are not recommended as they may damage the capacitor. Voltage Range: 25 Volts and 50 Volts PERFORMANCE SPECIFICATIONS Operating Temperature Range: –25°C to +85°C (–13°F to +185°F) CASE SIZE AND DIMENSIONS: Leakage Current: I ≤ 0.2CV (measured after 5 minutes of applied rated voltage) Insulating Sleeve I = Leakage Current (µA) C = Nominal Capacitance (µf) V = Rated Voltage (V) dØ Capacitance Tolerance: ±20% (M) measured at +20°C (+68°F), 1kHZ L’ Load Life: 1000 Hrs @ 12V DC, +70°C (+158°F), at specified ripple current Leakage Current: Initial specified value or less Dissipation Factor: < 200% of specified value Capacitance Change: Within ±15% of initial value Shelf Life: 500 Hrs @ +85°C (+185°F), no voltage applied Leakage Current: Initial specified value or less Dissipation Factor: < 200% of specified value Capacitance Change: Within ±15% of initial value ORDERING INFORMATION HD Series 4.7 15.0 Min M 50 A ±0.5 5.0 Min D’ Ø HD Series Dimensions: Diameter (D Ø) x Length (L): mm Capacitance (µf) 1.0 12.5 x 20 Ripple Current* (Ap–p) 2.0 2.2 12.5 x 25 3.0 3.3 16 x 25 4.0 4.7 16 x 31.5 5.0 5.6 16 x 31.5 6.0 6.8 16 x 35.5 7.0 8.2 18 x 35.5 8.0 18 x 40 9.0 10.0 25V and 50V * Allowable ripple current @ 70°C, 12V DC, and 15.75kHZ HD Mechanical Specs: Dimensions (mm) Capacitance Outside Diameter (D Ø) 12.5 16 18 Tolerance Lead Spacing (A) 5.0 7.5 7.5 Voltage Lead Wire (d Ø) 0.6 0.8 0.8 NTE Electronics, Inc. D Voice (800) 631–1250 (973) 748–5089 D FAX (973) 748–6224 D http://www.nteinc.com 9