WWW.PHIHONG.COM Single Port PoE Gigabit Switch Powered by IEEE802.3at Extends Ethernet Data and PoE to 200 Meters Features IEEE802.3af Class 4 0-55C Operating Temperature Range Gigabit Compatible Extends Ethernet to 200 meters Powered by IEEE802.3at with Layer 1 Detects 25K signature resistance Boost Circuit to Compensate for Wire Drops 1 Year Warranty Applications IP Cameras Access Controls Wireless Access Points Height: 32mm (1.26in) Weight: 0.6Kg (1.3lb) Safety Approvals CE Mechanical Characteristics Length: 120mm (4.72in) Width: 60mm (2.36in) Output Specifications Model POE16S-1AFG DC Output Voltage Min. Typ. Max. 54V 56V 57V Output Current Min. Max. 10mA 330mA Output Power 19W Phihong is not responsible for any error, and reserves the right to make changes without notice. Please visit our website at www.phihong.com for the most up-to-date specifications and contact information. WWW.PHIHONG.COM POE16S-1AFG Characteristics INPUT: Input Source Receives power from IEEE802.3at Midspan Input Detection 25K Detection IEEE802.3at compliance DC Input Voltage Range 45VDC to 57VDC DC Input Current 1.0A at 45VDC and maximum load 2.0A at 50VDC and maximum load 0.8A at 57VDC and maximum load OUTPUT: Total Output Power 19W with 33.6W PoE Input Ripple and Noise (Vp-p) 250mV maximum Output Detection 25K Detection IEEE802.3af compliance Efficiency 75% minimum at maximum load ENVIRONMENTAL Operating Temperature 0 to 40°C (gigabit data rates) Operating Temperature 0 to 55°C (10Mb and 100Mb data rates) Storage Temperature -25 to +65°C Humidity 5 to 90% EMI EN55022 Class A, FCC part 15 Class A Warranty 1 Year Immunity ESD EN61000-4-2 RS EN61000-4-3 Surge EN61000-4-5 Level 3 Level 3 Level 2 Isolation (HI-POT) 2121VDC for 1 min, 10mA Insulation Resistance Input to Ground: >10M OHM 500VDC Output to Ground: >10M OHM 500VDC FEATURES Over Current Protection For PoE Class 0-3 Detection on Output: 450mA maximum For PoE Class 4 Detection on Output:650mA maximum Short Circuit Protection Outputs equipped with short circuit protection The output can be shorted permanently without damage Indicators Ethernet – IN/OUT POE Green LED1 and LED2 10Mb Activity Green LED1 – 100Mb Activity Green LED2 – 1Gb Activity Orange LED3 – Link Activity Blinking GREEN – Unit is ON Active with No Load Solid GREEN – Unit has detected a valid IEEE802.3af load Blinking RED/GREEN – unit has detected an invalid load Solid RED – unit is in over-load condition Input/Output Connectors RJ45 Input Connection Pins: 1,2 7,8 GND / Pins: 3,6 4,5 +VIN Output Connection Pins: 1,2 GND / Pins: 3,6 +VIN Dimension Diagram Unit: mm WWW.PHIHONG.COM