WWW.PHIHONG.COM 8-Port 95W per Port Midspan Mega Power over Ethernet Midspan Features Proprietary Detection (12.5K), Disconnect and Overload Protection SNMP v2c Management Mega PoE 95W per Port Diagnostic LEDs 1U Rack Mounting Kit Ships with Unit Applications Wireless Access Points Computer Workstations Kiosks Fully Compliant Detection, disconnect and Voltage Control per IEEE802.3at Gigabit Compatible Full Protection OCP, OVP Limited Power Source 1 Year Warranty Security Systems IP Cameras Magnetic Locks Safety Approvals CE cUL/UL Mechanical Characteristics Length: 438mm (17.25in) Width: 228mm (8.98in) Height: 44.5mm (1.75in) 3.8Kg (8.5lbs) Output Specifications Model (1) POE806U-8MP-N-R DC Output Voltage 56V Load Min. 15mA Max.(2) 1.69A Output Power per Port 95W Note (1): Model without SNMP management available upon special request. Note (2): Max load applies to compliant load at 12.5K detection. If operating at 25K “IEEE802.3at mode” max load is 0.6A Phihong is not responsible for any error, and reserves the right to make changes without notice. Please visit our website at www.phihong.com for the most up-to-date specifications and contact information. Revision 6/21/2012 WWW.PHIHONG.COM POE806U-8MPN Characteristics INPUT: AC Input Voltage Rating 100 to 240VAC EMC EN55022 Class A, FCC Class A with UTP cabling EN55022 Class B, FCC Class B with FTP cabling AC Input Voltage Range 90 to 264VAC Isolation Test Primary to Secondary: 4242VDC for 1 minute Primary to Ground: 2121VDC for 1 minute Secondary to Ground: 2121VDC for 1 minute AC Input Current 15.0A (RMS) 90VAC at maximum load 10.0A (RMS) 230VAC at maximum load AC Input Frequency 47 to 63Hz Leakage Current < 3.5mA maximum at 264VAC, 60Hz Max In-Rush Current: 30A for 115VAC at maximum load 60A for 230VAC at Maximum load (Cold Start at Ambient 25°C) OUTPUT: Total Output Power 95W per port 760W Maximum Total Power Ripple (P-P) 250mV maximum Efficiency 75% (typical) at maximum load, and 120VAC 60Hz Hold-Up Time 16mS min. 120VAC and maximum load Transient O/P Voltage Protection 60V maximum at switch on and off at any AC line Phase Turn-On Delay Time (for PoE detection) 20 sec maximum at maximum load, 120VAC 60Hz Immunity EN50082-1 ESD: EN61000-4-2 RS: EN61000-4-3 EFP: EN61000-4-4 Surge: EN61000-4-5 CS: EN61000-4-6 Voltage Dips: EN61000-4-11 Harmonic: EN61000-3-2 Level 3 Level 2 Level 2 Level 3 Level 2 Class A IEEE802.3af/at Interoperability If 25K Ohm is detected then the unit operates in “IEEE802.3at mode” 33.6W 2 pair powering. 12.5K detection resistance required for full power 95W/port. Over-Voltage/Current, Short Circuit Protection Outputs equipped with short circuit protection and overload protection as per 802.3af specification except at maximum average current is 1.69A The output can be shorted permanently without damage Over Temperature Protection Automatic shutdown without damage Indicators Solid Green LED: Power detected “ON” Flashing Green: IEEE802.3at or (af) detected Yellow LED: Fault detected SNMPv2c management port Interface NIC interface for remote management via secure IP access Input Connector (Standard Model) AC Input IEC320 C14 ENVIRONMENTAL Temperature Operation Non-Operation 0 to +40C -25 to +65C Output Connection 4-pair powering for full power Pins 3,6, 4,5(+) Pins 1,2, 7,8 (-) Humidity Operation Non-Operation 5 to 90% 5 to 90% 2-pair powering for IEEE802.3at mode Pins 3,6(+) Pins 1,2 (-) Warranty 1 Year POE806U-8MPN Dimension Diagram Unit: mm WWW.PHIHONG.COM