WWW.PHIHONG.COM 2 Port 95W per Port Power over Ethernet Midspan Mega PoE Midspan Features Fully Compliant Detection, Disconnect and Voltage Control IEEE802.3af Proprietary Detection, Disconnect and Overload Protection Full Protection OCP, OVP Kit available for mounting in a 19” Rack Applications LCD Displays Wireless Access Points Emergency Lights Magnetic Locks Safety Approvals cUL/UL Mechanical Characteristics Length: 224.9mm (8.85in) Width: 200mm (7.87in) Output Specifications Limited Power Source Gigabit Compatible Diagnostic LEDs SNMP Management Full Power at 95W per port 1 Year Warranty Computer Stations Kiosks Outdoor Security Cameras Medical Monitoring CE Height: 48.5 mm (1.91in) Weight: 1.59Kg (3.5lbs) Model Number of Ports POE240U-2MPN 2 Optional 19” Rack mounting adapter to mount 1 POE240U or 2 side by side; order P/N POE125U-ACCY01 Phihong is not responsible for any error, and reserves the right to make changes without notice. Please visit our website at www.phihong.com for the most up-to-date specifications and contact information. Revision 9/26/2012 POE240U-2MPN Characteristics INPUT: AC Input Voltage Range WWW.PHIHONG.COM Insulation Resistance 90 to 264VAC Primary to Secondary: >10M OHM 500VDC Primary to Field Ground: >10M OHM 500VDC Input Frequency Immunity EN50082-1 47-63Hz ESD: RS: EFT: Surge: CS: Voltage Dips Harmonic: Input Current 5A (RMS) maximum for 90VAC 2.5A (RMS) maximum for 230VAC Leakage Current EN61000-4-2. Level 3 EN61000-4-3. Level 2 EN61000-4-4. Level 2 EN61000-4-5. Level 3 EN61000-4-6. Level 2 EN61000-4-11 EN61000-3-2 Class A 3.5mA maximum at 254VAC 60Hz IEEE 802.3af Interoperability AC Inrush Current 30A (RMS) maximum for 115VAC 60A (RMS) maximum for 230VAC OUTPUT: Total Output Power 60W per port at 56V+1/-2 Total power on all ports 240W Ripple and Regulation 250mV maximum If 25kohm is detected the unit operates in “IEEE802.3at mode” 33.6W 2 pair powering. 12.5k detection resistance required for full power UNH Interoperability report available on request FEATURE: Cisco Legacy detection No extern parts required for Legacy devices: VoIP Phones: 7910, 7912, 7940, 7960 Access Points: 350, 1100, 1200, 1250 Efficiency 75% (typical) at maximum load, and 120VAC 60Hz Over Voltage/Current, Short Circuit Protection Hold-up Time Outputs equipped with short circuit protection and overload protection as per 802.3af specifications except for maximum average current is 1.69A The output can be shorted permanently without damage 10mS min. 120VAC and maximum load Transient O/P Voltage Protection 60V maximum at switch on and off at any AC line Phase Over Temperature Protection Automatic Shutdown without damage Turn-On Delay Time 20 sec maximum at maximum load, and 120VAC 60Hz, 25Hz Indicators ENVIRONMENTAL: Temperature Green LED: Power detected “CONNECT” at 60W Flashing GREEN: IEEE802.3at detected “CONNECT” at 30W Yellow LED: Fault detected Operation Non-operation Input Connector 0 to +40°C -25 to +65°C AC Input IEC320 3 pin Humidity Operation 5 to 90% EMC EN55022 Radiate Class A EN55022 Conducted Class B Isolation Test Primary to Secondary: 4242VDC for 1 minute Primary to Ground: 2121VDC for 1 minute Secondary to Ground: 2121VDC for 1 minute Output Connection 4-pair powering for full power Pins 3,6, 4,5(+) Pins 1,2, 7,8 (-) 2-pair powering for IEEE802.3at mode Pins 3,6(+) Pins 1,2 (-) Warranty 1 Year POE240U-2MPN Dimension Diagram (mm) Façade Display Showing Optional Rack Mounting WWW.PHIHONG.COM