XVT9011 • • • • Voltage Controlled Temperature Compensated Crystal Oscillator Excellent Frequency Stability & Low Phase Noise 3.2 x 2.5 x 1.2 mm Surface-mount Case Complies with Directive 2002/95/EC (RoHS) Pb 13.000000 MHz SM3225-4 Case Electrical Characteristics Characteristic Nominal Frequency Sym Notes Minimum fo Typical Maximum 13.000000 Units MHz Component Storage Temperature Range -30 +85 °C Storage Temperature Range in Tape and Reel -30 +85 °C 260 °C +70 °C Soldering Profile, 10 seconds, up to 5 cycles Operating Temperature Range -20 Power Supply Voltage Vcc 3.14 Output Voltage with Load 10 pF||10 K Vout 0.8 Output Waveform Power Supply Current Control Voltage Control Voltage Input Impedance 3.30 3.46 V VP-P clipped sinewave Icc Vcon 2.0 0.5 2.5 100K Frequency Tolerance, Single Solder Reflow, Vcontrol = 1.50 V mA V ohms ±2.0 ppm max @ 25 °C ±2 °C Frequency Stability versus: Temperature, -20 to 70 °C ±0.5 ppm Supply Voltage, 3.14 to 3.46 V ±0.2 ppm Load 10 pF||10 K±10% ±0.2 Control Voltage Frequency Range, 0.5 to 2.5 V ±3 Start Up Time, 90% of final RF level in VP-P Aging @ 25 °C ppm ±7 5.0 ±1 ppm/V ms ppm/year Harmonics -5.0 dBc SSB Phase Noise @ 1 kHz Carrier Offset -130 dBc/Hz Lid Symbolization 9011/YWWS CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. Notes: 1. The design, manufacturing process, and specifications of this device are subject to change without notice. www.RFM.com E-mail: [email protected] © 2010-2011 by RF Monolithics, Inc. Page 1 of 3 XVT9011 - 2/21/12 SM3225-4 Case 4-Terminal Surface-Mount Seam Weld Case 3.2 x 2.5 mm Nominal Footprint Top Side Bottom D E C A 4 3 B F G H 2 1 I Typical PCB Land Pattern Dimension J A B C D E F G H I J K L M K L M Min mm Nom Max 3.00 2.30 - 3.20 2.50 3.08 1.80 2.38 1.00 0.65 0.60 3.60 1.60 2.90 0.80 3.40 2.70 1.20 - Min Inches Nom Max 0.118 0.091 - 0.126 0.098 0.121 0.071 0.094 0.039 0.026 0.024 0.142 0.063 0.114 0.031 0.133 0.106 0.047 - Application Circuit V Pin Connection 1 Vcontrol 2 GND/CASE GND 3 Output 4 Vcc www.RFM.com E-mail: [email protected] © 2010-2011 by RF Monolithics, Inc. C o n tro l V o lta g e In p u t 1 2 V C o T e m C o m o lta g e n tr o lle p e ra tu p e n s a C ry s ta l O s c illa to C C 4 d 1 0 n F re te d r 3 O u tp u t Page 2 of 3 XVT9011 - 2/21/12 Reel Dimensions mm A B C D E F G H T1 T2 T3 Dimension 180 60 13.0 2.0 9.1 2.9 4.9 3.9 9.0 11.4 1.2 Tolerance ±1.0 +1.0/-0.0 ±0.2 ±0.5 ±0.5 ±0.5 ±0.5 ±0.5 ±0.3 ±1.0 ±0.1 Tape Dimensions mm A0 B0 W F E P0 P1 P2 D1 D K0 t Dimension 2.80 3.71 8.00 3.50 1.75 4.00 4.00 2.00 1.50 1.00 1.75 0.25 Tolerance ±0.10 ±0.10 +0.30/-0.10 ±0.05 ±0.10 ±0.10 ±0.10 ±0.05 +0.10/-0.00 +0.25/-0.00 ±0.10 ±0.02 www.RFM.com E-mail: [email protected] © 2010-2011 by RF Monolithics, Inc. Page 3 of 3 XVT9011 - 2/21/12