SLPOWER RSC350

RSC350 RAINBOW SERIES SWITCHERS
FEATURES:
Automatic line range selection
Fully regulated and floating outputs
Modular output configurations
FCC, CISPR22 Class B
"Smart Load" feature eliminates minimum load
requirements
• For medical version, see p. 116
• 2-year warranty
marked to LVD
•
RAINBOW SERIES SWITCHERS
•
•
•
•
•
SPECIFICATIONS:
AC Input
90-132 and 180-264Vac, 50/60Hz single phase.
Input Current
9/4.5A.
Hold-Up Time
20mSec minimum from loss of AC input at full load, nominal line (115Vac).
Output Power
350W with cover fan option (390W peak).
Overload Protection
Standard on all outputs; revovery automatic.
Overvoltage Protection
Standard on all outputs within ranges below:
OUTPUT
OVP SETTING
V ADJ. RANGE
5V
5.6-6.8V
4.6-5.5V
12V & 15V
18-22V
11.5-15.3V
24V & 28V
29-35V
22.0-30.0V
Efficiency
74% minimum at full load; nominal input voltage.
Turn-on Time
Less than 1 second.
Input Protection
Internal AC fuse provided. Designed to blow only if a catastrophic failure
occurs in the unit—fuse does not blow on overload or short circuit.
Inrush Current
60A maximum.
Temperature Coefficient
0.03%/ºC typical on all units.
Environmental
Designed for 0 to 50°C operation at full rated output power; derate
output current and total output power by 2.5% per °C above 50°C. See
Environmental and Packaging Specifications (p. 11) for additional
information.
Power Fail
A TTL signal goes low upon failure, 6mS min. before output drops 5%.
Output Noise
0.5% RMS, 1% Pk-Pk, measured directly across output terminals.
Transient Response
Main output—500 µSec typical response time for return to within 0.5% of
final value for a 50% load step change. ∆i/∆t<0.2A/µSec. Maximum
voltage deviation is 3.5%.
Remote Sense
Standard on main output; will compensate for 0.5V of cabling losses.
Voltage Adjustment
Built-in potentiometers adjust outputs minimum of ±5%.
Reverse Voltage Protection
All outputs protected against inadvertent application of reverse voltage up
to 1 times rated current of the reversed output.
Leakage Current
100µA.
EMI/EMC Compliance
All models include built-in EMI filtering to meet the following emissions
requirements:
EMI SPECIFICATIONS
COMPLIANCE LEVEL
Conducted Emissions
EN55022 Class B; FCC Class B
Static Discharge
EN61000-4-2, 6 kV contact, 3 kV air
RF Field Susceptibility
EN61000-4-3, 3 V/meter
Fast Transients/Bursts
EN61000-4-4, 2 kV, 5 kHz
Surge Susceptibility
EN61000-4-5, 1 kV diff., 2 kV com.
Safety
Approved to UL1950 (no D3 deviations), CSA22.2 No. 234L6, IEC950
and EN60950.
Vibration
Designed to meet requirements of MIL-STD 810E, Method 514.4
Category 1. This test consists of random vibration at 0.015g/Hz from 5 to
50Hz declining linearly to 0.15g2/Hz in each axis for one hour.
Shock
Designed to meet MIL-STD 810E, Method 516.4. Unpackaged units shall
meet the bench handling requirements of Procedure VI for four drops per
face.
Condor D.C. Power Supplies, Inc./A subsidiary of SL Industries, Inc.
2311 Statham Parkway, Oxnard, CA 93033 • 800-235-5929 • 805-486-4565 • FAX 805-487-8911 • www.condorpower.com/
52
Aux 1
Aux 2
Aux 3
RSC350BBB
5V @ 40A
12V @ 12A
12V @ 4A
12V @ 4A
RSC350DBB
5V @ 40A
24V @ 6A
12V @ 4A
12V @ 4A
RSC350DAC
5V @ 40A
24V @ 6A
5V @ 4A
15V @ 4A
RSC350BAD
5V @ 40A
12V @ 12A
5V @ 4A
24V @ 2.5A
RSC350BAB
5V @ 40A
12V @ 12A
5V @ 4A
12V @ 4A
RSC352BAB
24V @ 8A
12V @ 12A
5V @ 4A
12V @ 4A
RSC352BAD
24V @ 8A
12V @ 12A
5V @ 4A
24V @ 2.5A
RSC352BBB
24V @ 8A
12V @ 12A
12V @ 4A
12V @ 4A
RSC352DAC
24V @ 8A
24V @ 6A
5V @ 4A
15V @ 4A
RSC352DBB
24V @ 8A
24V @ 6A
12V @ 4A
12V @ 4A
RAINBOW SERIES SWITCHERS
Main
Model
Output configurations:
"A" auxiliary output adjusts from 4.7 to 5.3Vdc—available on Aux 2 only.
"B" auxiliary output adjusts from 11.5 to 15.5Vdc.
"C" same as "B" but factory set at 15Vdc.
"D" auxiliary output adjusts from 23 to 29Vdc—available on Aux 1 & 3.
RSC350 MECHANICAL SPECIFICATIONS:
INPUT: TB1 TERMINAL BLOCK, #6-32 x 0.375"
PIN 1) AC LINE
PIN 2) AC NEUTRAL
PIN 3) CHASSIS GROUND
OUTPUT: BUSSBAR
+V1 +5V @ 40A
COMMON +5V RTN
OUTPUT: TB2 TERMINAL BLOCK, #6-32 x 0.375
PIN 1) AUX #1 (RTN)
PIN 2) AUX #1 (+)
PIN 3) AUX #2 (RTN)
PIN 4) AUX #2 (+)
PIN 5) AUX #3 (RTN)
PIN 6) AUX #3 (+)
OUTPUT VOLTAGE ADJUST.:
R39 OUT 1 V. ADJ.(AUX4)
R25 OUT 2 V. ADJ.(AUX1)
R6 OUT 3 V. ADJ.(AUX2)
R6 OUT 4 V. ADJ.(AUX3)
SIGNALS: J1 AMP P/N 640456-5
PIN 1) POWER GOOD
PIN 2) POWER FAIL
PIN 3) INHIBIT HI
PIN 4) +SENSE
PIN 5) -SENSE
R31 POWER FAIL ADJ.
FAN CONN: AMP P/N 640456-2
+12V 0-0.5 AMP
WEIGHT: 4.0 LBS. MAX. (1.82 kg MAX.)
3.59
W/ OPTIONAL
COVER & FAN
[91.19mm]
3.65
[92.71mm]
0.76
[19.30mm]
AUX 3
R6
TB1
L
N
GND
1
2
F1
PWR LIM.
FACTORY
SET
1
8.000 [203.20mm]
[127.00mm]
6
AUX 1
V2 ADJ
3.300
[83.82mm]
AIR
FLOW
10-32
SCREW
2PL
1
T2
3
5.00
TB2
8
R25
16
W/ OPTIONAL COVER
2.45
AUX 2
R6
R77
FAN AUX 4 R39 J1
V1 ADJ
+5V COM R31
PF
J1
ADJ
0.89
[22.61mm]
0.77
[19.56mm]
0.75 [19.05mm]
0.660
[16.76mm]
9.50 [241.30mm]
8.500 [215.90mm]
1.11
[28.19mm]
0.50
[12.70mm]
1.500
[38.10mm]
(1.77)
[44.96mm]
(2.45)
PIN 1
[62.23mm]
R39
8-32 MTG
0.120 [3.05mm] MAX.
(SCREW PENETRATION)
4PL (THIS SURFACE)
4PL (ON BOTTOM)
63.75 ± 1.27mm
[62.23mm]
T3
9
2.51 ± 0.05
OPTIONAL FAN
LOCATION
2.36
[59.94mm]
TYP
J1
0.50
[12.70mm]
TOLERANCES: X.XX=0.030 [0.76mm]
X.XXX=0.010 [0.25mm]
Condor D.C. Power Supplies, Inc./A subsidiary of SL Industries, Inc.
2311 Statham Parkway, Oxnard, CA 93033 • 800-235-5929 • 805-486-4565 • FAX 805-487-8911 • www.condorpower.com/
53