SLPOWER GEM600-36G

GEM600
600W Single Output Economy/Technology Switchers
Commercial and Medical
2 Year Warranty
•600W Single Output AC-DC Power Supply
•Universal Input 90-264 VAC
•Standard: Active PFC, OVP, Power Fail and Inhibit (low)
•Modified and Customized Designs also available
•Complies with EMI/RFI Standards
•Approved to EN/IEC/UL/CSA 60950-1 for ITE
•Approved to EN/IEC/UL60601-1 for Medical
•
Compliant (LVD, RoHS)
Specifications
All Specifications are typical at nominal input, full load at 25°C unless otherwise stated.
AC Input
90-264VAC, 47-63 Hz single phase.
Input Current
120VAC: 9A, 230VAC: 4.5A.
Inrush Current
Limited by internal thermistor. The inrush at 240VAC, averaged over
the first AC half-cycle under cold start conditions will not exceed 40A.
Input Fuse
F1, F2: 12A, 250VAC fuses provided on all models.
Power Factor
0.99 typical, 0.96 minimum.
Earth Leakage Current
120VAC: 75µA max. NC, 120µA max. SFC.
264VAC: 160µA max. NC, 300µA max. SFC.
Output Power
600W continuous.
Peak Output Power
650W for 1 minute, 10% duty cycle.
Output Voltage
See chart.
Voltage Adjustability
Adjustable potentiometer, capable of ±5% change from nominal.
Minimum Load
Not required.
Total Regulation
See chart.
Transient Response
500µs max., 50% load step, ∆i/∆t < 0.2A/µs.
Enclosure Dimensions
See outline drawing
Turn On Time
Less than 2 seconds under all rated load conditions.
Hold-up Time
≥20 ms from loss of AC input at 600W load, 120VAC input.
Over/Undershoot
3.5% max. at turn-on, 1% max. at turn-off.
Output Overload & Short Circuit Protection
Foldback, then cycle-by-cycle current limiting, automatic recovery.
Overvoltage Protection
Latching type, recycle AC input to reset. See chart for trip levels.
Ripple and Noise
1% pk-pk max., 20MHz BW, differential mode. Measured with noise
probe directly across output terminals.
ITE Safety Standards
CSA/EN/IEC/UL 60950-1
Medical Safety Standards
EN/IEC/UL 60601-1
Efficiency
>80% typical at full rated load
Switching Frequency
140KHz main inverter and 70kHz PFC (synchronized).
MTBF
208K hours per Telcordia.
Overtemperature Protection
Automatic.
Weight
3.75 lbs. (1.70kg)
Signals
AC Power Fail: TTL “0” 10ms before the output drops to <97% of nom.
Inhibit:
Short inhibit pin to output common to Inhibit.
1 of 4
______________________________________________________________________________________________________________________________
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: [email protected] • www.slpower.com
GEM600
600W Single Output Economy/Technology Switchers
Commercial and Medical
2 Year Warranty
Output Parameters
Model
Number
Volts (V) ┌────── Output Current
Nominal
───────┐
Peak
Ripple
& Noise
Total
Regulation
OVP
Threshold
GEM600-24G
24V
25.0A
27.0A
240mV
±1.0%
30.0 ± 2V
GEM600-28G
28V
21.5A
23.5A
280mV
±1.0%
33.0 ± 3V
GEM600-36G
36V
16.7A
18.0A
360mV
±1.0%
43.0 ± 3V
GEM600-48G
48V
12.5A
13.5A
480mV
±1.0%
56.0 ± 4V
Environmental Specifications
Operating Temperature
-20° to 70°C. Derate output power for operation above 50°C. Fan
integral to the power supply.
Storage Temperature
-40 to +85°C
Relative Humidity
5% to 95%, non-condensing
Vibration
Operating:
0.003 g2/Hz, 1.5 grms overall, 3 axes, 10 min. / axis
Non-Operating:
0.026 g2/Hz, 5.0 grms overall, 3 axes, 1 hr. / axis
Shock
Operating:
Half-sine, 20 gpk, 10 ms, 3 axes, 6 shocks total
Non-Operating: Half-sine, 40 gpk, 10 ms, 3 axes, 6 shocks total
Temperature Coefficient
0.03% per °C typical on all units.
Output Power Derating
Derate Output Power by 2.5% per °C up to 70°C maximum.
Thermal Shutdown
Provided to avoid prolonged over-temperature condition.
Operating Altitude
-500 to 10,000 ft.
Non-operating Altitude
-500 to 40,000 ft.
EMI/EMC Compliance
RF Emissions
EN55011/22 and FCC Part 15, radiated Class A, conducted Class B.
Static Discharge Immunity
EN61000-4-2, 6kV Contact Discharge, 8kV air discharge
Radiated RF Immunity
EN61000-4-3, 3V/m.
EFT/Burst Immunity
EN61000-4-4, 2kV/5kHz..
Line Surge Immunity
EN61000-4-5, 1kV differential, 2kV common-mode
Conducted RF Immunity
EN61000-4-6, 3V
Power Frequency Magnetic Field Immunity
EN61000-4-8, 3A/m
Voltage Dip Immunity
EN61000-4-11, see EN60601-1-2: 2001 chart below.
Line Frequency Harmonics
EN61000-3-2, Class A
Voltage Fluctuations/Flicker
EN61000-3-3, Complies (clause 5b)
EN60601-1-2: 2001 Voltage Sag Compliance
Voltage Test Level
Voltage Dip
Duration
Output Voltage
Input Voltage
Input Voltage
Periods
Deviation
100VAC
<5 VAC
10mS
<3.5%
100VAC
40 VAC
100mS
<3.5%
100VAC
70 VAC
500mS
<3.5%
240VAC
<12 VAC
10mS
<3.5%
240VAC
96 VAC
100mS
<3.5%
240VAC
168 VAC
500mS
<3.5%
Note:
During 100mS voltage dip (5 cycles at 40%VAC), the AC Power Fail warning may trigger. During low line 100mS voltage dip, reduced loading to 50%
rated load is required to meet the deviation requirement and regulation.
2 of 4
______________________________________________________________________________________________________________________________
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: [email protected] • www.slpower.com
GEM600
600W Single Output Economy/Technology Switchers
Commercial and Medical
2 Year Warranty
Connector Information
INPUT CONNECTOR (TB1):
Option:
A
T
Pin 1
AC Line
Ground
Pin 2
Neutral
Neutral
DC OUTPUT CONNECTORS (TB2, TB3):
Pin 3
Manufacturer's P/N:
Ground EBY P/N 6002-03-N-01
AC Line Phoenix Contact P/N 1706785
TB2 All Pins
MATING CONNECTORS:
Option:
A
B
C
D
Option: Mate For:
Manufacturer's P/N:
C
TB2, TB3
Phoenix Contact P/N 1913523
All
J4
AMP P/N 1375820-4
All other options' connector is a terminal block or has a direct wire connection.
Pin 1
Pwr Good
Pin 2
Pwr Fail
+Vout
+Vout
+Vout
+Vout
TB3 All Pins
-Vout
-Vout
-Vout
-Vout
Manufacturer's P/N:
EBY P/N 6002-03-N-01
Bussbar #10-32UNC x 0.375 Screw
Phoenix Contact P/N 1998959
Phoenix Contact P/N 1731721
SIGNAL CONNECTOR (J4) (all options):
Pin 3
N/C
Pin 4
Manufacturer's P/N:
Inhibit AMP P/N 640456-4
“A” Option Input Connector:
“T” Option Input Connector:
“A” Option Output Connectors:
“C” Option Output Connector:
“D” Option Output Connector:
Model Number Configuration
GEM 600 - VV W X
Y ZZ G
ROHS COMPLIANT
VALUE-ADDED CONFIGURATIONS:
Blank = Standard Model
OPTIONAL DIODE:
Blank = None
D = N+1 OR'ing Diode
OUTPUT CONNECTOR:
A = EBY P/N 6002-03-N-01
B = Buss Bars 10-32 UNC x 0.375 SCREWS
C = Phoenix Contact P/N 1998959
D = Phoenix Contact P/N 1731721
INPUT CONNECTOR:
A = EBY P/N 5000-03-N-12
T = Phoenix Contact P/N: 1706785
OUTPUT VOLTAGE:
24 = 24Vdc @ 31.2A
28 = 28Vdc @ 26.8A
36 = 36Vdc @ 20.8A
48 = 48Vdc @ 17.0A
OUTPUT POWER
MODEL SERIES
3 of 4
______________________________________________________________________________________________________________________________
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: [email protected] • www.slpower.com
GEM600
600W Single Output Economy/Technology Switchers
Commercial and Medical
2 Year Warranty
Mechanical Specifications
Data Sheet © 2009 SL Power Electronics Corp. The information and specifications contained herein are believed to be correct at the time of publication.
Rev. 5-19-2009
However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice.
4 of 4
______________________________________________________________________________________________________________________________
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: [email protected] • www.slpower.com