D06D Series • MOSFET output • Ratings from 60A to 100A @ 60 VDC • DC control • Relays are easily paralleled for higher-current applications PRODUCT SELECTION Control Voltage 3.5-32 VDC 60A 80A 100A D06D60 D06D80 D06D100 OUTPUT SPECIFICATIONS (1) Description Operating Voltage Range Maximum Off-State Leakage Current @ Rated Voltage [mA] Maximum On-State Resistance @ Rated Current [RDS-ON][Ohms] Maximum Load Current (3) [Adc] Minimum Load Current [mA] Maximum Surge Current [Adc] (10ms) Maximum On-State Voltage Drop @ Rated Current [Vdc] Thermal Resistance Junction to Case (Rjc) [°C/W] 0-60 VDC 0.1 0.010 60 5 180 0.6 0.6 0-60 VDC 0.2 0.008 80 5 220 0.7 0.47 0-60 VDC 0.3 0.005 100 5 270 0.5 0.32 INPUT SPECIFICATIONS (1) Description DC Control Control Voltage Range Minimum Turn-On Voltage Minimum Turn-Off Voltage Maximum Input Current Nominal Input Impedance Maximum Turn-On Time [μsec] Maximum Turn-Off Time [msec] 3.5-32 VDC 3.5 VDC 1.0 VDC 1.6 mA (5 VDC), 28 mA (32 VDC) See Note 4 300 1.0 GENERAL SPECIFICATIONS Description Dielectric Strength, Input/Output/Base (50/60Hz) Minimum Insulation Resistance (@ 500 V DC) Maximum Capacitance, Input/Output Ambient Operating Temperature Range Ambient Storage Temperature Range Weight (typical) Encapsulation Terminals Recommended Terminal Screw Torque Range: Parameters 2500 Vrms 109 Ohm 50 pF -30 to 80°C -40 to 125 °C 3.0 oz (86.5g) Thermally conductive Epoxy Screws and Saddle Clamps Furnished, Unmounted 6-32 Screws - 10 in lbs. 8-32 and 10-32 Screws -20 in. lbs. (Screws dry without grase) GENERAL NOTES 1) All parameters at 25°C unless otherwise specified. 2) Dielectric strength and insulation resistance are measured between input and output. 3) Heat sinking required, see derating curves. 4) Input circuitry incorporates active current limiter MECHANICAL SPECIFICATIONS THERMAL DERATE INFORMATION WIRING DIAGRAM AGENCY APPROVALS Designed in accordance with the requirements of IEC 62314 Rev. 022812 ANNEX - ENVIROMENTAL INFORMATION