5.0X6.0mm SURFACE MOUNT LED LAMP ATTENTION OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DISCHARGE SENSITIVE DEVICES AA5060TGC GREEN Features Description z SINGLE The Green source color devices are made with InGaN COLOR. z SUITABLE FOR ALL SMT ASSEMBLY AND SOLDER Static electricity and surge damage the LEDS. PROCESS. z AVAILABLE z IDEAL zRoHS It is recommended to use a wrist band or ON TAPE AND REEL. anti-electrostatic glove when handling the LEDs. FOR BACKLIGHTING. z PACKAGE on SiC Light Emitting Diode. : 500PCS / REEL. All devices, equipment and machinery must be COMPLIANT. electrically grounded. . Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Specifications are subject to change without notice. SPEC NO: DSAD0901 APPROVED: J. Lu REV NO: V.3 CHECKED: Allen Liu DATE: MAR/09/2005 DRAWN: S.H.CHEN PAGE: 1 OF 4 ERP:1201001118 Selection Guide Part No. Dice AA5060TGC Iv (mcd) @ 30mA Lens Type GREEN (InGaN) WATER CLEAR Viewing Angle Min. Typ. 2θ1/2 70 250 100° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Green λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 500 nm IF=20mA Green 505 nm IF=20mA Spectral Line Half-width Green 30 nm IF=20mA C Capacitance Green 56 pF VF=0V;f=1MHz VF Forward Voltage Green 3.6 4.4 V IF=20mA IR Reverse Current Green 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Green Units Power dissipation 132 mW DC Forward Current 30 mA Peak Forward Current [1] 150 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD0901 APPROVED: J. Lu REV NO: V.3 CHECKED: Allen Liu DATE: MAR/09/2005 DRAWN: S.H.CHEN PAGE: 2 OF 4 ERP:1201001118 Green SPEC NO: DSAD0901 APPROVED: J. Lu AA5060TGC REV NO: V.3 CHECKED: Allen Liu DATE: MAR/09/2005 DRAWN: S.H.CHEN PAGE: 3 OF 4 ERP:1201001118 AA5060TGC Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength), the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAD0901 APPROVED: J. Lu REV NO: V.3 CHECKED: Allen Liu DATE: MAR/09/2005 DRAWN: S.H.CHEN PAGE: 4 OF 4 ERP:1201001118