MUR2100E Preferred Device SWITCHMODE Power Rectifier Ultrafast “E” Series with High Reverse Energy Capability http://onsemi.com . . . designed for use in switching power supplies, inverters and as free wheeling diodes, these state–of–the–art devices have the following features: ULTRAFAST RECTIFIER 2 AMPERES 1000 VOLTS • 20 mjoules Avalanche Energy Guaranteed • Excellent Protection Against Voltage Transients in Switching • • • • • Inductive Load Circuits Ultrafast 75 Nanosecond Recovery Time 175°C Operating Junction Temperature Low Forward Voltage Low Leakage Current High Temperature Glass Passivated Junction Mechanical Characteristics • Case: Epoxy, Molded • Weight: 0.4 gram (approximately) • Finish: All External Surfaces Corrosion Resistant and Terminal • • • • • Leads are Readily Solderable Lead and Mounting Surface Temperature for Soldering Purposes: 220°C Max. for 10 Seconds, 1/16″ from case Shipped in plastic bags, 1000 per bag Available Tape and Reeled, 5000 per reel, by adding a “RL’’ suffix to the part number Polarity: Cathode Indicated by Polarity Band Marking: MUR2100E AXIAL LEAD CASE 059–04 PLASTIC MARKING DIAGRAM MUR2100E MAXIMUM RATINGS Symbol Value Unit Peak Repetitive Reverse Voltage Working Peak Reverse Voltage DC Blocking Voltage Rating VRRM VRWM VR 1000 Volts Average Rectified Forward Current (Note 1.) (Square Wave Mounting Method #3 Per Note 3.) IF(AV) 2.0 @ TA = 35°C Amps Non-Repetitive Peak Surge Current (Surge applied at rated load conditions, halfwave, single phase, 60 Hz) IFSM 35 Amps Operating Junction Temperature and Storage Temperature Range TJ, Tstg October, 2000 – Rev. 1 ORDERING INFORMATION Device Package Shipping MUR2100E Axial Lead 1000 Units/Bag MUR2100ERL Axial Lead 5000/Tape & Reel °C –65 to +175 Preferred devices are recommended choices for future use and best overall value. 1. Pulse Test: Pulse Width = 300 µs, Duty Cycle ≤ 2.0%. Semiconductor Components Industries, LLC, 2000 MUR2100E = Device Code 1 Publication Order Number: MUR2100E/D MUR2100E THERMAL CHARACTERISTICS Characteristic Maximum Thermal Resistance, Junction to Ambient Symbol Value Unit RθJA See Note 3. °C/W ELECTRICAL CHARACTERISTICS Maximum Instantaneous Forward Voltage (Note 2.) (IF = 2.0 Amp, TJ = 150°C) (IF = 2.0 Amp, TJ = 25°C) vF Volts Maximum Instantaneous Reverse Current (Note 2.) (Rated dc Voltage, TJ = 100°C) (Rated dc Voltage, TJ = 25°C) iR Maximum Reverse Recovery Time (IF = 1.0 Amp, di/dt = 50 Amp/µs) (IF = 0.5 Amp, IR = 1.0 Amp, IREC = 0.25 A) trr Maximum Forward Recovery Time (IF = 1.0 A, di/dt = 100 A/µs, IREC to 1.0 V) tfr 75 ns WAVAL 10 mJ 1.75 2.20 µA 600 10 ns 100 75 Controlled Avalanche Energy (See Test Circuit in Figure 6) 2. Pulse Test: Pulse Width = 300 µs, Duty Cycle ≤ 2.0%. 10 I , INSTANTANEOUS FORWARD CURRENT (AMPS) F I F , INSTANTANEOUS FORWARD CURRENT (AMPS) 10 VF @ 175°C 1.0 VF @ 150°C 1.0 150°C 125°C 100°C 75°C 25°C 0.1 0.5 0.7 0.9 1.1 1.3 1.5 1.7 0.1 1.9 25°C 0.5 0.7 0.9 1.1 1.3 1.5 1.7 1.9 VF, INSTANTANEOUS VOLTAGE (VOLTS) VF, INSTANTANEOUS VOLTAGE (VOLTS) Figure 1. Maximum Forward Voltage Figure 2. Typical Forward Voltage http://onsemi.com 2 2.1 2.3 MUR2100E 1000 100 10 25°C 1.0 125°C 10 75°C 1.0 25°C 0.1 0.01 0.1 0 200 400 600 800 0.001 1000 400 600 800 VR, REVERSE VOLTAGE (VOLTS) Figure 4. Typical Reverse Current 3.0 2.0 dc 1.0 SQUARE WAVE 0 200 VR, REVERSE VOLTAGE (VOLTS) 4.0 0 0 Figure 3. Maximum Reverse Current PF(AV) , AVERAGE POWER DISSIPATION (WATTS) IF(AV) , AVERAGE FORWARD CURRENT (AMPS) 150°C 100°C IR @ 150°C 100 IR, REVERSE CURRENT ( A) IR @ 175°C 100 50 150 200 4.0 3.0 dc 2.5 2.0 1.5 1.0 0.5 0 0 0.5 1.0 1.5 2.0 IF(AV), AVERAGE FORWARD CURRENT (AMPS) Figure 5. Current Derating Figure 6. Power Dissipation 20 TJ = 25°C 10 7.0 5.0 3.0 2.0 0 10 20 30 40 VR, REVERSE VOLTAGE (VOLTS) Figure 7. Typical Capacitance http://onsemi.com 3 1000 SQUARE WAVE 3.5 TA, AMBIENT TEMPERATURE (°C) C, CAPACITANCE (pF) IR, REVERSE CURRENT ( A) 1000 50 2.5 MUR2100E NOTE 3. — AMBIENT MOUNTING DATA Data shown for thermal resistance junction to ambient (RθJA) for the mountings shown is to be used as typical guideline values for preliminary engineering or in case the tie point temperature cannot be measured. TYPICAL VALUES FOR RθJA IN STILL AIR Mounting Method 1 2 RθJA Lead Length, L 1/4 1/2 1/8 52 65 72 67 80 87 Units °C/W °C/W 50 °C/W 3 MOUNTING METHOD 1 L L ÉÉÉÉÉÉÉÉÉÉÉ MOUNTING METHOD 2 ÉÉÉÉÉÉÉÉÉÉÉÉ ÉÉÉÉÉÉÉÉÉÉÉÉ L L Vector Pin Mounting ÉÉ ÉÉ ÉÉ ÉÉ ÉÉ ÉÉ ÉÉ MOUNTING METHOD 3 L = 3/8 ″ Board Ground Plane P.C. Board with 1–1/2 ″ X 1–1/2 ″ Copper Surface http://onsemi.com 4 MUR2100E PACKAGE DIMENSIONS MINI MOSORB CASE 59–04 ISSUE M B K D NOTES: 1. ALL RULES AND NOTES ASSOCIATED WITH JEDEC DO-41 OUTLINE SHALL APPLY. 2. POLARITY DENOTED BY CATHODE BAND. 3. LEAD DIAMETER NOT CONTROLLED WITHIN F DIMENSION. DIM A B D K A MILLIMETERS MIN MAX 5.97 6.60 2.79 3.05 0.76 0.86 27.94 --- K http://onsemi.com 5 INCHES MIN MAX 0.235 0.260 0.110 0.120 0.030 0.034 1.100 --- MUR2100E Notes http://onsemi.com 6 MUR2100E Notes http://onsemi.com 7 MUR2100E SWITCHMODE is a trademark of Semiconductor Components Industries, LLC. ON Semiconductor and are trademarks of Semiconductor Components Industries, LLC (SCILLC). SCILLC reserves the right to make changes without further notice to any products herein. SCILLC makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does SCILLC assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation special, consequential or incidental damages. “Typical” parameters which may be provided in SCILLC data sheets and/or specifications can and do vary in different applications and actual performance may vary over time. All operating parameters, including “Typicals” must be validated for each customer application by customer’s technical experts. SCILLC does not convey any license under its patent rights nor the rights of others. SCILLC products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in which the failure of the SCILLC product could create a situation where personal injury or death may occur. Should Buyer purchase or use SCILLC products for any such unintended or unauthorized application, Buyer shall indemnify and hold SCILLC and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that SCILLC was negligent regarding the design or manufacture of the part. SCILLC is an Equal Opportunity/Affirmative Action Employer. PUBLICATION ORDERING INFORMATION NORTH AMERICA Literature Fulfillment: Literature Distribution Center for ON Semiconductor P.O. Box 5163, Denver, Colorado 80217 USA Phone: 303–675–2175 or 800–344–3860 Toll Free USA/Canada Fax: 303–675–2176 or 800–344–3867 Toll Free USA/Canada Email: [email protected] Fax Response Line: 303–675–2167 or 800–344–3810 Toll Free USA/Canada N. American Technical Support: 800–282–9855 Toll Free USA/Canada EUROPE: LDC for ON Semiconductor – European Support German Phone: (+1) 303–308–7140 (Mon–Fri 2:30pm to 7:00pm CET) Email: ONlit–[email protected] French Phone: (+1) 303–308–7141 (Mon–Fri 2:00pm to 7:00pm CET) Email: ONlit–[email protected] English Phone: (+1) 303–308–7142 (Mon–Fri 12:00pm to 5:00pm GMT) Email: [email protected] CENTRAL/SOUTH AMERICA: Spanish Phone: 303–308–7143 (Mon–Fri 8:00am to 5:00pm MST) Email: ONlit–[email protected] Toll–Free from Mexico: Dial 01–800–288–2872 for Access – then Dial 866–297–9322 ASIA/PACIFIC: LDC for ON Semiconductor – Asia Support Phone: 303–675–2121 (Tue–Fri 9:00am to 1:00pm, Hong Kong Time) Toll Free from Hong Kong & Singapore: 001–800–4422–3781 Email: ONlit–[email protected] JAPAN: ON Semiconductor, Japan Customer Focus Center 4–32–1 Nishi–Gotanda, Shinagawa–ku, Tokyo, Japan 141–0031 Phone: 81–3–5740–2700 Email: [email protected] ON Semiconductor Website: http://onsemi.com EUROPEAN TOLL–FREE ACCESS*: 00–800–4422–3781 *Available from Germany, France, Italy, UK, Ireland For additional information, please contact your local Sales Representative. http://onsemi.com 8 MUR2100E/D