ADS-155 155W Single Output with 5V, 3A DC-DC Converter series Features : Universal AC input / Full range Built-in active PFC function Protections: Short circuit / Overload / Over voltage Cooling by free air convection 100% full load burn-in test Fixed switching frequency at PFC 67KHz, PWM 134KHz 2 years warranty http://www.meanwellchina.com SPECIFICATION MODEL OUTPUT INPUT ADS-15512 CH2 CH1 CH2 CH1 DC VOLTAGE 12V 5V 24V 5V 48V 5V RATED CURRENT 11.5A 3A 5.8A 3A 2.9A 3A CURRENT RANGE 0 ~ 12.5A 0 ~ 3A 0 ~ 6.5A 0 ~ 3A 0 ~ 3.2A 0 ~ 3A RATED POWER 153W 154.2W 100mVp-p RIPPLE & NOISE (max.) Note.2 150mVp-p 150mVp-p VOLTAGE ADJ. RANGE CH1:10.8 ~ 13.2V VOLTAGE TOLERANCE Note.3 2.0% CH1:21.6 ~ 26.4V 1.0% 3.0% CH2 154.2W 100mVp-p 3.0% 240mVp-p CH1:43.2 ~ 52.8V 1.0% 100mVp-p 5.0% LINE REGULATION 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% LOAD REGULATION 1.0% 2.0% 0.5% 2.0% 1.0% 1.0% SETUP, RISE TIME 1000ms, 90ms/230VAC HOLD UP TIME (Typ.) 24ms/230VAC VOLTAGE RANGE 88 ~ 264VAC FREQUENCY RANGE 47 ~ 63Hz POWER FACTOR (Typ.) PF>0.92 EFFICIENCY (Typ.) 77% AC CURRENT (Typ.) INRUSH CURRENT (Typ.) 2.5A/115VAC OVERLOAD PROTECTION OVER VOLTAGE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS SAFETY & WITHSTAND VOLTAGE ISOLATION RESISTANCE EMC (Note 4) EMC EMISSION 2000ms, 90ms/115VAC at full load 20ms/115VAC at full load 124 ~ 370VDC 82% COLD START 20A/115VAC <1mA / 240VAC 40A/230VAC 105 ~ 135% rated output power Protection type : Constant current limiting, recovers automatically after fault condition is reoved CH1:13.8 ~ 16.2V CH1:27.6 ~ 32.4V CH1:55.2 ~ 64.8V Protection type : Shut down o/p voltage, re-power on to recover -10 ~ +60 (Refer to "Derating Curve") 20 ~ 90% RH non-condensing -20 ~ +85 , 10 ~ 95% RH 0.03%/ (0 ~ 50 ) 10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes UL60950-1, TUV EN60950-1 approved I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH Compliance to EN55022 (CISPR22) Class B, EN61000-3-2,-3 EMC IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A 202.3K hrs min. MIL-HDBK-217F (25 199*110*50mm (L*W*H) 1Kg; 16pcs/16Kg/0.95CUFT DIMENSION 82% 1.5A/230VAC MTBF PACKING NOTE ADS-15548 CH1 LEAKAGE CURRENT OTHERS ADS-15524 OUTPUT NUMBER ) 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to EMI testing of component power supplies. (as available on http://www.meanwell.com) File Name:ADS-155-SPEC 2011-06-16 ADS-155 155W Single Output with 5V, 3A DC-DC Converter Mechanical Specification Case No. 906B series Unit:mm 192 5 172 3.5 12 6 100 1 9.5 2 3 97 110 4 8.2 5 6 5-M3 7 37 8 199 6 6.5 3.5 50 3M3 20 20 12 24.5 3.5 25 16.5 190.5 Terminal Pin No. Assignment Pin No. 1 2 3 4 Assignment AC/L AC/N FG +5V Pin No. 5 6,7 8 Assignment NC DC OUTPUT COM DC OUTPUT +V 159 PFC fosc : 67KHz PWM fosc : 134KHz Block Diagram SWITCHING REGULATOR EMI FILTER & RECTIFIERS I/P PFC CIRCUIT RECTIFIERS & FILTER POWER SWITCHING FG O.L.P. +V -V CONSTANT CURRENT LIMITING & DETECTION CIRCUIT PWM & PFC CONTROL ACTIVE START CIRCUIT +5V O.V.P. Derating Curve Output Derating VS Input Voltage (15512) 100 100 +12V 90 With 21.6 CFM min.(10cm) 80 80 70 With NO FAN LOAD (%) LOAD (%) 60 40 20 -10 60 50 40 0 10 20 30 40 50 AMBIENT TEMPERATURE ( ) 60 70 (HORIZONTAL) 88 90 100 120 140 160 180 200 220 240 264 INPUT VOLTAGE (V) 60Hz File Name:ADS-155-SPEC 2011-06-16