TEMEX SAW BANDPASS FILTER FB F334 - BASE STATION - PCS-CDMA RX Specification All performances include temperature variations Minimum Source / load impedance (single ended) Ω Operating temperature range °C Center frequency Fc Typical Maximum 50 0 +80 MHz 70 Template on the amplitude, reference is minimum insertion loss Bandwidth at –1.5 dB MHz Bandwidth at –35.0 dB MHz 1.50 Bandwidth at –50.0 dB MHz 1.80 Insertion loss at Fc 1.26 dB Amplitude ripple in Fc ± 0.615 MHz dB Phase linearity in Fc ± 0.615 MHz deg Ultimate attenuation 20 23 1 p-p 10 p-p dB 50 Package type & size DIP Length x width mm2 Height mm 73.0 x 20.0 6.5 Pin Out Input 2 Output 11 Input return 17 Output return 8 Case Ground 1, 3, 4, 5, 6, 7, 8, 9, 10, To Be Grounded 12, 13, 14, 15, 16, 17, 18 Matching network for 50 Ω / 50 Ω configuration C1 Input 50 Ω L1 2 11 C2 C4 L2 C3 17 Output 50 Ω 8 GND GND Temex Microsonics test fixture L1 = 200 nH / C1 = 22 pF ± 5% / C2 = 12 pF ± 5% L2 = 200 nH / C3 = 22 pF ± 5% / C4 = 12 pF ± 5% L1 and L2 are tunable inductors TBD = To be defined on customer PC board 1 This datasheet has been downloaded from http://www.digchip.com at this page TEMEX reserves the right to modify herein specifications and information at any time when necessary to provide optimum performance and cost. Note: (1) With matching network TEMEX SAW BANDPASS FILTER FB F334 - BASE STATION - PCS-CDMA RX Center frequency Loss reference Delay reference Phase reference = 70 MHz = 16.75 dB = 10.98 µs = 91.36 deg Scale frequency = 1 MHz/div Scale amplitude = 10 dB/div Center frequency Loss reference Delay reference Phase reference = 70 MHz = 16.75 dB = 10.98 µs = 91.36 deg Scale frequency = 0.2 MHz/div Scale amplitude = 0.5 dB/div Scale phase = 1.25 deg/div 2 TEMEX reserves the right to modify herein specifications and information at any time when necessary to provide optimum performance and cost. Typical response