Oscilent Corporation IF SAW Filter | 809-SL140.0M-18 Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 809-SL140.0M-18 9.1 x 6.5 SMD Base Station & Repeater Apr 18, 2007 . TYPE : 140.0 MHz Bandpass Filter Low Loss PART NUMBER : 809-SL140.0M-18 .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units Center Frequency - 140.0 - MHz Insertion Loss at Fo - 8.5 11.0 dB Operating Temperature Range -30 - +80 °C Storage Temperature Range -40 - +85 °C Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Bandwidth at -1.0 dB 17.2 18.2 - MHz Bandwidth at -3.0 dB 18.0 19.2 - MHz Bandwidth at -35.0 dB - 22.8 25.0 MHz dB - Relative Attenuation: from 100 to 124 MHz 40 46 - from 156 to 180 MHz 40 44 - dB Amplitude Ripple - 0.6 1.0 dBp-p Group Delay Variation - 55 100 nsec Absolute Delay at Fo - 0.88 - µsec Temperature Coefficient - -94 - ppm/°C In/Out Return Loss at Fo - - - dB *With Matching Network (Reference Testing Environment Circuit as shown) Modifiy Impedance Values as necessary. . PACKAGE OUTLINE (mm) TEST FIXTURE Oscilent Corporation IF SAW Filter | 809-SL140.0M-18 Page 2 of 2 PIN Descriptions IN-2,OUT-7,GROUND-1,3,4,5,6,8,9,10 FREQUENCE CHARACTERISTICS Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 809-SL140.0M-18