Order this document by MHW2707A/D SEMICONDUCTOR TECHNICAL DATA The RF Line Designed for 7.5 volt UHF power amplifier applications in industrial and commercial equipment primarily for hand portable radios. • Specified 7.5 Volt Characteristics: RF Input Power: 1 mW (0 dBm) RF Output Power: 7 W Minimum Gain (Vcont = 7 V): 38.5 dB Harmonics: – 35 dBc Max @ 2 fo • Provides Wideband Performance • Meets European Transient Specification (ETS 300 113) • Epoxy Glass PCB Construction Gives Consistent Performance and Reliability • 50 Ω Input/Output Impedances • Guaranteed Stability and Ruggedness 7W 400–470 MHz UHF POWER AMPLIFIER CASE 301AL–01, STYLE 1 MAXIMUM RATINGS (Flange Temperature = 25°C) Symbol Value Unit VDD1, 2, 3 9 Vdc Vcont 7 Vdc Pin 2 mW RF Output Power (VDD1, 2, 3 = 9 V) Pout 9 W Operating Case Temperature Range TC – 30 to +80 °C Storage Temperature Range Tstg – 30 to +80 °C Rating DC Supply Voltage (Pins 2, 4, 5) DC Control Voltage (Pin 3) RF Input Power MOTOROLA RF DEVICE DATA Motorola, Inc. 1997 MHW2707A1 1 ELECTRICAL CHARACTERISTICS (VDD1 = VDD2 = VDD3 = 7.5 Vdc (Pins 2, 4, 5); TC = +25°C, 50 ohm system unless otherwise noted) Characteristic Symbol Min Max Unit BW 400 470 MHz Vcont 0 7 Vdc Quiescent Current (VDD1 = VDD2 = VDD3 = 7.5 Vdc; Pin = 0 mW, Vcont = 0 Vdc) — — 1 mA Power Gain (Pout = 7 W, Vcont = 7 Vdc) Gp 38.5 — dB Efficiency (Pout = 7 W; Pin = 1 mW) (1) η 45 — % Frequency Range Control Voltage (Pout = 7 W; Pin = 1 mW) (1) Harmonics (Pout = 7 W; Pin = 1 mW) (1) 2 fo Input VSWR (Pout = 7 W; Pin = 1 mW, 50 Ω Ref.) (1) Control Current (VDD1= VDD2 = VDD3 = 7.5 Vdc; Pin = 1 mW) (1) — — –35 dBc VSWRin — 3 — Icont — 2 mA Load Mismatch Stress (VDD1 = VDD2 = VDD3 = 9 Vdc; Pin = 2 mW; Pout = 9 W; Load VSWR = 10:1, All Phase Angles at Frequency of Test) (1) ψ No Degradation in Output Power Before & After Test Stability (Pin = 1 – 2 mW; VDD1 = VDD2 = VDD3 = 6 – 9 Vdc; Pout = between 0.1 mW and 9 W; Load VSWR = 8:1, All Phase Angles at Frequency of Test) (1) — All Spurious Outputs More Than 60 dB Below Desired Signal (1) Adjust Vcont for Specified Pout. MHW2707A1 CIRCUIT BLOCK DIAGRAM 1 C1 2 3 C2 4 5 6 C2 L1 L1 L1 L1 Z1 Z2 C1 RF INPUT VDD1 C1 Vcont C3 C3 C2 VDD2 C2 VDD3 RF OUTPUT Pin Designations: Element Values: Pin 1 — RF Input Power (0 dBm) Pin 2 — VDD1 (7.5 Vdc) Pin 3 — Vcont (0 – 7 Vdc) Pin 4 — VDD2 (7.5 Vdc) Pin 5 — VDD3 (7.5 Vdc) Pin 6 — RF OUT (7 Watts nom.) C1 = 0.018 µF C2 = 0.1 µF C3 = 3.3 µF L1 = 0.22 µH CHOKE Z1 = Z2 = 50 Ω Microstrip Line Figure 1. UHF Power Module Test Circuit Schematic and Device Block Diagram MHW2707A1 2 MOTOROLA RF DEVICE DATA PACKAGE DIMENSIONS NOTES: 1. DIMENSIONING AND TOLERANCING PER ANSI Y14.5M, 1982. 2. CONTROLLING DIMENSION: INCH. 3. DIMENSION F TO CENTER OF LEADS. 4. REF INDICATES NON–CONTROLLED DIMENSION FOR REFERENCE USE ONLY. –Z– 1.02 (0.040) T A M R –A– G –B– M J 123 4 –S– 5 6 K Q 2 PL Y 0.33 (0.013) M W X D 6 PL T B M L N H 0.20 (0.008) P 6 PL 0.25 (0.010) M T S F E C –T– M SEATING PLANE T M A M DIM A B C D E F G H J K L N P Q R S V X X INCHES MIN MAX 1.760 1.780 1.370 1.390 0.245 0.265 0.017 0.023 0.080 0.100 0.132 BSC 1.650 BSC 1.290 BSC 0.266 0.280 0.230 0.300 1.090 BSC 1.190 BSC 0.010 REF 0.118 0.132 0.535 0.555 0.445 0.465 0.590 BSC 0.790 BSC 0.390 BSC STYLE 1: PIN 1. 2. 3. 4. 5. 6. CASE: MILLIMETERS MIN MAX 44.70 45.21 34.80 35.31 6.22 6.73 0.43 0.58 2.03 2.54 3.35 BSC 41.91 BSC 32.77 BSC 6.76 7.11 5.84 7.62 27.69 BSC 30.25 BSC 0.25 REF 3.00 3.35 13.59 14.10 11.30 11.81 14.99 BSC 20.07 BSC 9.91 BSC RF INPUT VDD1 VCONT VDD2 VDD3 RF OUTPUT GROUND CASE 301AL–01 ISSUE O MOTOROLA RF DEVICE DATA MHW2707A1 3 Motorola reserves the right to make changes without further notice to any products herein. Motorola makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does Motorola assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation consequential or incidental damages. “Typical” parameters which may be provided in Motorola data sheets and/or specifications can and do vary in different applications and actual performance may vary over time. All operating parameters, including “Typicals” must be validated for each customer application by customer’s technical experts. Motorola does not convey any license under its patent rights nor the rights of others. Motorola products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in which the failure of the Motorola product could create a situation where personal injury or death may occur. Should Buyer purchase or use Motorola products for any such unintended or unauthorized application, Buyer shall indemnify and hold Motorola and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that Motorola was negligent regarding the design or manufacture of the part. Motorola and are registered trademarks of Motorola, Inc. Motorola, Inc. is an Equal Opportunity/Affirmative Action Employer. Mfax is a trademark of Motorola, Inc. How to reach us: USA / EUROPE / Locations Not Listed: Motorola Literature Distribution; P.O. Box 5405, Denver, Colorado 80217. 303–675–2140 or 1–800–441–2447 JAPAN: Nippon Motorola Ltd.: SPD, Strategic Planning Office, 4–32–1, Nishi–Gotanda, Shinagawa–ku, Tokyo 141, Japan. 81–3–5487–8488 Mfax: [email protected] – TOUCHTONE 602–244–6609 ASIA/PACIFIC: Motorola Semiconductors H.K. Ltd.; 8B Tai Ping Industrial Park, – US & Canada ONLY 1–800–774–1848 51 Ting Kok Road, Tai Po, N.T., Hong Kong. 852–26629298 INTERNET: http://motorola.com/sps MHW2707A1 4 ◊ MHW2707A/D MOTOROLA RF DEVICE DATA