D200RP Series Short Circuit Protected Regulated, 2W SIP DC/DC Converters Electrical Specifications Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice. Input Key Features: ● 2W Output Power ● Short Circuit Protection ● Tight Line/Load Regulation ● 1,000 VDC Isolation ● Miniature SIP Case ● >1.5 MHour MTBF ● 15 Standard Models Parameter Conditions 5 VDC Input Input Voltage Range Min. Typ. Max. 4.5 5.0 5.5 12 VDC Input 10.8 12.0 13.2 24 VDC Input 21.6 24.0 26.4 Input Filter Units VDC π (Pi) Filter Reverse Polarity Input Current 0.3 A Max. Units ±2.0 % ±0.5 % Output Parameter Conditions Min. Typ. Output Voltage Accuracy Line Regulation For Vin Min to Max Load Regulation (Note 1) Ripple & Noise (20 MHz) (Note 2) Output Power Protection ±0.5 % 75 mV P - P ±0.02 %/ºC Max. Units 120 % Temperature Coefficient Output Short Circuit Continuous General Parameter Conditions Isolation Voltage Isolation Resistance Isolation Capacitance Min. 60 Seconds 1,000 500 VDC 1,000 100 kHz, 1V Switching Frequency Typ. VDC MΩ 60 pF 40 kHz Environmental Parameter Min. Typ. Max. Units Operating Temperature Range Conditions Ambient -25 +25 +71 ºC Operating Temperature Range Case -25 +85 ºC -40 +125 ºC 95 % Storage Temperature Range Cooling Humidity MicroPower Direct Free Air Convection RH, Non-condensing Physical 232 Tosca Drive Stoughton, MA 02072 USA Case Size T: (781) 344-8226 F: (781) 344-8481 E: [email protected] W: www.micropowerdirect.com Reliability Specifications 1.26 x 0.32 x 0.55 Inches (32.0 x 8.0 x 14.0 mm) Case Material Non-Conductive Black Plastic (UL94-V0) Weight Parameter MTBF 0.17 Oz (4.8g) Conditions Min. MIL HDBK 217F, 25ºC, Gnd Benign Typ. Max. 1.5 Units MHours Absolute Maximum Ratings Parameter Conditions Min. 5 VDC Input Input Voltage Surge (1 Sec) Lead Temperature Internal Power Dissipation -0.7 Typ. Max. Units 9.0 12 VDC Input -0.7 18.0 24 VDC Input -0.7 30.0 VDC 1.5 mm From Case For 10 Sec 260 ºC All Models 450 mW Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings. Model Selection Guide Model Number D201RP D202RP D203RP D204RP D205RP D211RP D212RP D213RP D214RP D215RP D221RP D222RP D223RP D224RP D225RP Notes: Input Voltage (VDC) Current (mA) Nominal Range Full-Load No-Load 5 4.5 - 5.5 606 80 5 4.5 - 5.5 606 80 5 4.5 - 5.5 571 80 5 4.5 - 5.5 571 80 5 4.5 - 5.5 588 80 12 10.8 - 13.2 253 45 12 10.8 - 13.2 253 45 12 10.8 - 13.2 238 45 12 10.8 - 13.2 238 45 12 10.8 - 13.2 246 45 24 21.6 - 26.4 130 25 24 21.6 - 26.4 130 25 24 21.6 - 26.4 122 25 24 21.6 - 26.4 122 25 24 21.6 - 26.4 118 25 1. Output load regulation is specified for a load change of 20% to 100%. 2. When measuring output ripple, it is recommended that an external 0.33 μF ceramic capacitor be placed from the +Vout pin to the -Vout pin. 3. Operation at no-load will not damage these units. However, they may not meet all specifications. 4. These do not require external components to operate, but the use of a low ESR capacitor (approximately 10 uF, ESR <1.0Ω at 100 kHz) mounted close to the converter input pins is recommended. 5. It is recommended that a fuse be used on the input of a power supply for protection. See the table above for the correct rating. Capacitive Load Voltage (VDC) 5.0 9.0 12.0 15.0 24.0 5.0 9.0 12.0 15.0 24.0 5.0 9.0 12.0 15.0 24.0 Output Current (mA, Max) 400.0 222.0 167.0 133.0 83.0 400.0 222.0 167.0 133.0 83.0 400.0 222.0 167.0 133.0 83.0 Current (mA, Min) 40.0 22.0 17.0 13.0 10.0 40.0 22.0 17.0 13.0 10.0 40.0 22.0 17.0 13.0 10.0 Efficiency (%, Typ) 66 66 70 70 68 66 66 70 70 68 64 64 68 68 70 Fuse Rating Slow-Blow (mA) 1,000 1,000 1,000 1,000 1,000 500 500 500 500 500 200 200 200 200 200 Derating Curve Pin Connections μF Max 470 Pin Function 1 +Vin 2 NC 3 NC 9 NC 10 -Vout 11 +Vout 12 -Vin Mechanical Dimensions NC: No Connection Notes: All dimensions are typical in inches (mm) Tolerance x.xx = ±0.01 (±0.25) Pin 1 is marked by a “dot” or indentation on the side of the unit MicroPower Direct www.micropowerdirect.com 232 Tosca Drive Stoughton, MA 02072 ■ TEL: (781) 344-8226 ■ FAX: (781) 344-8481 ■ E-Mail: [email protected]