EMA3 / UMA3N / FMA3A Transistors Emitter common (dual digital transistors) EMA3 / UMA3N / FMA3A zExternal dimensions (Unit : mm) (3) (4) (2) (5) 1.2 1.6 (1) 0.5 0.13 zStructure Epitaxial planar type PNP silicon transistor (Built-in resistor type.) 0.5 0.5 1.0 1.6 EMA3 0.22 zFeatures 1) Two DTA143Ts in a EMT or UMT or SMT package. 2) Mounting cost and area can be cut in half. Each lead has same dimensions ROHM : EMT5 Abbreviated symbol : A3 2.0 (2) (1) 1.3 (3) (4) (6) 0.65 0.65 UMA3N 0.2 The following characteristics apply to both DTr1 and DTr2. 1.25 zEquivalent circuit DTr1 (1) 0.9 Abbreviated symbol : A3 FMA3A 2.9 (2) 1.1 DTr2 Each lead has same dimensions ROHM : UMT5 EIAJ : SC-88A 0.8 R1 0.95 0.95 1.9 (5) R1 (3) (4) (4) (5) (3) (5) DTr1 (4) 0.1Min. R1=4.7kΩ 1.6 2.8 0.3to0.6 0to0.1 DTr2 0to0.1 FMA3A (1) R1 (2) R1 (2) (1) (3) 0.3 R1=4.7kΩ 0.15 EMA3 / UMA3N 0.7 0.15 2.1 Each lead has same dimensions ROHM : SMT5 EIAJ : SC-74A Abbreviated symbol : A3 Rev.A 1/2 EMA3 / UMA3N / FMA3A Transistors zAbsolute maximum ratings (Ta=25°C) Symbol Limits Unit Collector-base voltage VCBO −50 V Collector-emitter voltage VCEO −50 V Emitter-base voltage VEBO −5 V IC −100 mA Parameter Collector current Collector power dissipation EMA3, UMA3N 150 (TOTAL) PC mW 300 (TOTAL) FMA3A Junction temperature Tj 150 ˚C Storage temperature Tstg −55 to +150 ˚C ∗1 ∗2 ∗1 120mW per element must not be exceeded. ∗2 200mW per element must not be exceeded. zElectrical characteristics (Ta=25°C) Parameter Symbol Min. Typ. Max. Unit Conditions Collector-base breakdown voltage BVCBO −50 − − V Collector-emitter breakdown voltage BVCEO −50 − − V IC=−1mA Emitter-base breakdown voltage BVEBO −5 − − V IE=−50µA VCB=−50V IC=−50µA Collector cutoff current ICBO − − −0.5 µA DC current transfer ratio hFE 100 250 600 − Emitter cutoff current IEBO − − −0.5 µA VEB=−4V VCE (sat) − − −0.3 V IC/IB=−5mA/−0.25mA fT − 250 − MHz R1 3.29 4.7 6.11 kΩ Collector-emitter saturation voltage Transition frequency Input resistance VCE/IC=−5V/−1mA VCE=−10V, IE=5mA, f=100MHz ∗ − ∗ Transition frequency of the device zPackaging specifications Package Type Taping Code T2R TR T148 Basic ordering unit (pieces) 8000 3000 3000 EMA3 UMA3N FMA3A 1k VCE=−5V DC CURRENT GAIN : hFE 500 50 −1 −500m −200m 200 100 COLLECTOR SATURATION VOLTAGE : VCE (sat) (V) zElectrical characteristic curves −100m Ta=100˚C 25˚C −40˚C 20 10 5 2 1 −100µ −200µ −500µ −1m −2m lC/lB=20 Ta=100˚C 25˚C −40˚C −5m −10m −20m −50m −100m COLLECTOR CURRENT : IC (A) Fig.1 DC current gain vs. collector current −50m −20m −10m −5m −2m −1m −100µ −200µ −500µ −1m −2m −5m −10m −20m −50m−100m COLLECTOR CURRENT : IC (A) Fig.2 Collector-emitter saturation voltage vs. collector current Rev.A 2/2 Appendix Notes No technical content pages of this document may be reproduced in any form or transmitted by any means without prior permission of ROHM CO.,LTD. The contents described herein are subject to change without notice. The specifications for the product described in this document are for reference only. Upon actual use, therefore, please request that specifications to be separately delivered. Application circuit diagrams and circuit constants contained herein are shown as examples of standard use and operation. Please pay careful attention to the peripheral conditions when designing circuits and deciding upon circuit constants in the set. Any data, including, but not limited to application circuit diagrams information, described herein are intended only as illustrations of such devices and not as the specifications for such devices. ROHM CO.,LTD. disclaims any warranty that any use of such devices shall be free from infringement of any third party's intellectual property rights or other proprietary rights, and further, assumes no liability of whatsoever nature in the event of any such infringement, or arising from or connected with or related to the use of such devices. Upon the sale of any such devices, other than for buyer's right to use such devices itself, resell or otherwise dispose of the same, no express or implied right or license to practice or commercially exploit any intellectual property rights or other proprietary rights owned or controlled by ROHM CO., LTD. is granted to any such buyer. Products listed in this document are no antiradiation design. The products listed in this document are designed to be used with ordinary electronic equipment or devices (such as audio visual equipment, office-automation equipment, communications devices, electrical appliances and electronic toys). Should you intend to use these products with equipment or devices which require an extremely high level of reliability and the malfunction of with would directly endanger human life (such as medical instruments, transportation equipment, aerospace machinery, nuclear-reactor controllers, fuel controllers and other safety devices), please be sure to consult with our sales representative in advance. About Export Control Order in Japan Products described herein are the objects of controlled goods in Annex 1 (Item 16) of Export Trade Control Order in Japan. In case of export from Japan, please confirm if it applies to "objective" criteria or an "informed" (by MITI clause) on the basis of "catch all controls for Non-Proliferation of Weapons of Mass Destruction. Appendix1-Rev1.1