THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630)(630) 851-5040. 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM www.conwin.com P R O D UPCRT O D DU A TCAT SDHAE TEAT SHEET CRYSTAL CONTROLLED OSCILLATORS STRATUM 3E LVCMOS OCVCXO 3.3V ABSOLUTE MAXIMUM RATINGS PARAMETER Storage Temperature (Vcc) Input Voltage MINIMUM -55 NOMINAL - MAXIMUM 125 UNITS °C NOTE -0.5 - 4.5 Vdc -0.5 - Vcc+0.5 Vdc MINIMUM NOMINAL UNITS -0.2 -10 -1 -30 -40 10, 12.8,20 MAXIMUM - 5.00E-11 - 0.2 10 1 30 300 70 MHz ppm ppb ppb/day ppb RMS ppb °C 3.13 -0.5 -0.5 - 3.30 - -100 - 5 - 3.47 0.5 0.5 4.0 1.25 500 100 5 1 Vdc ppb ppb W W mS ppb ppb/G nS nS MINIMUM NOMINAL MAXIMUM UNITS NOTE 0.3 ±0.3 50K 1.65 - 3.3 ±1.0 - Vdc ppm Ohm 10 OPERATING SPECIFICATIONS OVC3CF4AA TABLE 2.0 PARAMETER Center Frequency Frequency Calibration (Vc= 1.65 Vdc) Frequency Stability Aging: Daily Aging: First Year Aging: Short Term (1Sec.) Aging: Long Term (20 Years) Operating Temperature Range (Fo) Supply Voltage Voltage Stability (+/-1%) Load Stability (+/-20%) Power Consumption: Turn On Power Consumption: Steady-State Start-Up Time Warm Up 2G Tip-over TDEV at 300 seconds TDEV at 40 seconds (Vcc) NOTE 1 2 3 4 5 6 6 7 8 PARAMETER Vc DESCRIPTION The Connor-Winfield OVC3CF4AA is a 3.3V Voltage Controlled Oven Controlled Crystal Oscillator (OCVCXO) with an LVCMOS output. The OVC3CF4AA is designed for Stratum 3E applications requiring low jitter and tight frequency stability. 9 9 TABLE 3.0 INPUT CHARACTERISTICS Control Voltage (Pin 1) Deviation @ 25°C referenced to Fo Input Impedance (Pin 1) MODEL OVC3CF4AA FREQUENCY 10.000MHz 0021 DATE CODE CAL. FREQ. 10.000000 TABLE 1.0 UNITS Supply Voltage CONNOR WINFIELD FEATURES DESIGNED TO MEET STRATUM 3E REQUIREMENTS VARIABLE FREQUENCY (OVCCXO) LVCMOS OUTPUT CHARACTERISTICS PARAMETER LOAD Voltage (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% Spurious Output SSB Phase Noise at 1Hz offset SSB Phase Noise at 10Hz offset SSB Phase Noise at 100Hz offset SSB Phase Noise at 1KHz offset (Voh) (Vol) SSB Phase Noise at 10KHz offset TABLE 4.0 MINIMUM 12 Vcc-0.2V 45 - NOMINAL 15 50 - MAXIMUM 18 0.2 55 5 -80 -90 -115 -130 -140 UNITS pF Vdc Vdc % nS dBc dBc/Hz dBc/Hz dBc/Hz dBc/Hz - - -150 dBc/Hz RESTABILIZATION TIME Off Time < 1 Hour < 6 Hours < 24 Hours 1 to 16 Days > 16 Days DATASHEET SHEET#:#: DATA Restabilization Time < 2 Hours < 12 Hours < 48 Hours 48 Hours + ¼ Off Time < 6 Days Cx133 Cx133 PAGE 11 PAGE OF 22 OF 00 REV: 01 REV: NOTE 11 FREQUENCY STABILITY ±10ppb TEMPERATURE RANGE -40 to 70°C 3.3V OPERATION LVCMOS OUTPUT RoHS 5/6 COMPLIANT ORDERING INFORMATION TABLE 5 .0 NOTE 12 12 12 12 12 8/17/07 DATE: 01/17/08 DATE: OVC3CF4AA OCXO SERIES - 010.0M CENTER FREQUENCY Specifications subject to change without notice. aCopyright Copyright 2008 2001 Connor-Winfield Connor-Winfield all all rights rights reserved. reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630)(630) 851-5040. 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM www.conwin.com P R O D UPCRT O D DU A TCAT SDHAE TEAT SHEET CRYSTAL CONTROLLED OSCILLATORS PACKAGE CHARACTERISTICS TABLE 6.0 Metal package: solder sealed, grounded case, solder tinned pins. RoHS 5/6 compliant, see solder profile below. Package Solder Process Pin Connections ENVIRONMNETAL CHARACTERISTICS TABLE 7.0 100G’s, 6mS, halfsine per MIL-STD-202F, Method 213B, Test Condition C 0.06” D.A. or 10G peak 10 to 500 Hz, per MIL-STD-202F, Method 204D, Test condition A Shock Vibration Notes: 1) 2) 3) 4) 5) 6) 7) 8) 9) 10) 11) 12) CONTROL VOLTAGE Labels will include the calibration frequency at the time of ship. Initial calibration @ 25 C, Vc=1.65Vdc, at time of shipment. Frequency vs. temperature stability, referenced to 25 C. After ten days of continuous operation. Allen Variance: 1 second, 100 average. Vcc = 3.3Vdc. From Vcc=90% of final value. No more than 16 transitions at start-up before oscillator has started. Measured @ -40 C, within 5 minutes, referenced one hour after turn-on. After stabilization in a controlled airflow environment. At time of delivery. LVCMOS load. For a given off time, the time required to meet daily aging, short-term stability and TDEV requirements. Labeling Diagram MODEL OVC3CF4AA FREQUENCY 10.000MHz DATE CODE 0021 CAL. FREQ. 10.000000 Package Outline .500 12.700mm Solder Profile Test Circuit Temperature 225°C Ramp-Up Rate 3°C/second max. from 150°C to 225°C. 225°C tp Ramp-Down Rate 6°C/second max. 183°C 150°C +3.3Vdc 100°C 25°C CONTROL VOLTAGE (Vc) 0 Time 60-120s Max. 10-30s 60-150s Max. 360 Sec. Max. Specifications subject to change without notice. DATA SHEET SHEET #: #: DATA Cx133 Cx133 PAGE PAGE 12 OF OF 22 00 REV: REV: 01 DATE: DATE: 8/17/07 01/17/08 a Copyright 2001 2008 Connor-Winfield Connor-Winfield all all rights rights reserved. reserved. aCopyright