OC-48 SR-1/STM-16 I-16 SFP Transceiver SP-48-SR1 Features • Data rate 2.488 Gb/s • Single 3.3 V supply • 2 km reach •10 dB min. link budget • Commercial and Industrial temperature available • 1310 FP laser • SFP MSA SFF-8074i compliant • GR 253/STM G.957 compliant • Digital Diagnostic SFF-8472 compliant • Telcordia GR-468 compliant • RoHS 5/6 compliant (Lead Exemption) General Operating Symbol Min. Typ. Max. Supply Voltage Parameter Vcc 3.135 3.3 3.465 Unit V Total Current ICC - - 300 mA Power Supply Noise Rejectiona PSR 100 - - mVp-p Operating Case Temperature (-Txx) Topr -40 - 85 ºC Operating Case Temperature (-Cxx) Topr -5 - 70 ºC Storage Temperature Tstg -40 - 85 ºC Data Rate OC48/STM-16 DR - 2488.32 - Mbps a) 20Hz to 155MHz Transmitter Specifications, Optical Parameter Symbol Min Typical Max Unit Optical Power Pop -10 -5 -3 dBm Average Launch Power of Off Tx Poff - - -30 dBm Extinction Ratio (dynamic) ER 8.2 - - dB Eye Mask SONET/SDH compliant Optical Jitter Generation Jgen - - 0.002 UI Timeb tr - - 160 ps Optical Fall Timeb tf - - 160 ps Optical Rise λ 1266 - 1360 nm Maximum RMS Width ∆λ - - 4 nm Dispersion Penalty at 12ps/nm(4Km)c dp - 1 dB Relative Intensity Noise RIN - - -120 dB/Hz Reflectance Toleranced rp -24 - - dB Mean Wavelength b) 20%-80% values c) Measured at BER of 10-10, PRBS of 223-1, at eye center d) 1dB degradation of receiver sensitivity LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 1 LUMNDS1521-FEB1006 rev.A.0 OC-48 SR-1/STM-16 I-16 SFP Transceiver SP-48-SR1 Transmitter Specifications , Electrical Parameter Symbol Min Typical Max Unit Rin 80 100 120 Ω Vin, p-p 250 - 1200 mV Vfault 2 - Vcc V Vnormal Vd Vee - Vee + 0.5 V TxDisable_Disable 2 - Vcc V TxDisable_Enable Ven Vee - Vee + 0.8 V Parameter Symbol Min Typical Max Unit Receiver Power Lowe Rsens,low - -22 -20 dBm Receiver Power Highe Rsens,high -3 - - dBm Damage Threshold for Receiver Pin, damage - - 4 dBm λ 1266 - 1360 nm RX_r - - -27 dB LOS Assert - -30 - - dBm LOS De-assert - - - -20 dBm LOS Hysteresis - 1 - - dB Parameter Symbol Min Typical Max Unit PECL Single Ended Data Output Swing Vout,p-p 185 - 800 mV tr - - 175 ps tf - - 175 ps Input Differential Impedence PECL Single Ended data input swing TxFault_Fault TxFault_Normal Receiver Specifications, Optical Wavelengthf Maximum Reflectance of Receiver e) At 10-10 BER, PRBS 223-1 f) Operational over 1200-1625 nm range Electrical Output Data Output Rise Time Data Output Fall Time LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 2 LUMNDS1521-FEB1006 rev.A.0 OC-48 SR-1/STM-16 I-16 SFP Transceiver SP-48-SR1 Timing and Electrical Parameter Symbol Min Typical Max Unit Tx Disable Negate time t_on - Tx Disable assert time t_off - - 1 ms - 10 Time to initialize, including reset of Tx fault t_init µs - - 300 ms Tx fault Assert time t_fault - - 100 µs Tx Disable to reset t_reset 10 - - µs t_loss_on - - 100 µs t_loss_off f_serial_clock Rx_LOSH 2 - 100 100 - µs KHz V LOS Assert time LOS De-assert time Serial ID Clock Rate RX_LOS Voltage (high) RX_LOS Voltage (low) RX_LOSL - - 0.8 V LOS output voltage-Fault VLOS fault 2 - Vcc V VLOS normal Vee - Vee + 0.5 V MOD_DEF (0:2)-High Vh 2 - VI Vee - Vcc Vee + 0.5 V MOD_DEF (0:2)-Low LOS output voltage-Normal V Diagnostics Parameter Temperature (-TDx) Range Accuracy Unit Calibration Formula -40 to 85 ±3 ºC Internal Tc(C) = Tad(16 bit signed twos complement)/256 Tc(C) = Tad(16 bit signed twos complement)/256 Temperature (-CDx) -5 to 70 ±3 ºC Internal Voltage 0 to Vcc 0.1 V Internal V(Volts) = Vad(16 bit unsigned integer)*0.1 Bias Current 0 to 120 5 mA External I(mA) = Islope * Iad(16 bit unsigned integer)+Ioffset Tx Power -10 to -3 ±3dB dBm External Tx_PWR(µW) = Tx_PWRslope*Tx_PWRad(16 bit unsigned integer)+Tx_ PWRoffset Rx Power -20 to -3 ±3dB dBm External Rx_PWR(µW) = A0+A1*x+A2*x^2+A3*x^3+A4*x^4 LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 3 LUMNDS1521-FEB1006 rev.A.0 OC-48 SR-1/STM-16 I-16 SFP Transceiver SP-48-SR1 EEPROM Serial ID Name of Field Discription of Field SFPVendor name (ASCII) Vendor Name IEEE vendor OUI code for LuminentOIC Inc. Vendor OUI Part number in ASCII, e.g. SP-48-SR1-CDA Vendor PN Address Hex 20 4C ASCII L 21 55 U 22 4D M 23 49 I 24 4E N 25 45 E 26 4E N 27 54 T 28 4F O 29 49 I 30 43 C 37 00 38 06 39 B5 40 53 41 50 P 42 34 4 43 38 8 44 53 S 45 52 R 46 31 1 47 43 C 48 44 D 49 41 A S Pinout Definitions Pin Function Notes 1 VeeT TX GND 2 TX_FAULT Open Collector 3 TX_DISABLE Internally Pulled High 4 MOD_DEF2 Serial Data Input 5 MOD_DEF1 Serial Clock Input 6 MOD_DEF0 Internally Grounded 7 NC Not Connected 8 LOS Open Collector 9 VeeR RX Ground 10 VeeR RX Ground 11 VeeR RX Ground 12 RXD- RX Data Negative 13 RXD+ RX Data Positive 14 VeeR RX GND 15 VCCR RX Power 16 VCCT TX Power 17 VeeT TX GND 18 TXD+ TX Data Positive 19 TXD- TX Data Negative 20 VeeT TX GND LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 4 LUMNDS1521-FEB1006 rev.A.0 OC-48 SR-1/STM-16 I-16 SFP Transceiver SP-48-SR1 Outline Drawing Units in inches [mm] 45.009 1.772 1.448 .057 0.381 .015 8.357 .329 11.405 .449 8.484 .334 47.625 1.875 56.388 2.220 13.995 .551 0.127 .005 13.157 .518 13.411 .528 Suggested Transceiver Interface 1µH V CC 10 µF Protocol IC 0.1 µF 1µH VCC T .01µF R1 TX_DISABLE LuminentOIC SFP 10k Ω TX_DISABLE TX_FAULT TX_FAULT SerDes TD + Laser Driver .01µF 100Ω TD .01µF VEE T VCC R 10µF Receiver Amplifier 0.1µF RD + .01µF 100Ω RD .01µF RX_LOS RX_LOS V CC VEE R R1 R1 EEPROM R1 R1 MOD_DEF 2 MOD_DEF 1 MOD_DEF 0 R1 = 4.7Κ to 10ΚΩ LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 5 LUMNDS1521-FEB1006 rev.A.0 OC-48 SR-1/STM-16 I-16 SFP Transceiver SFP-2488-SR1 Ordering Information A vailable Options: SP-48-SR1-CDA SP-48-SR1-TDA SP-48-SR1-CNA SP-48-SR1-TNA Part numbering Definition: SP - 48 - SR1 - Temperature Diagnostic Revision • SP = Small Form Pluggable 48 = OC48 SR1 = Short Reach 2km • Operating Temperature C = Commeracial (-5 to 70) T = Industrial Temperature (-40 to 85) • D = Digital Diagnostic N = No Digital Diagnostic • Design Revision Warnings: Handling Precautions: This device is susceptible to damage as a result of electrostatic discharge (ESD). A static free environment is highly recommended. Follow guidelines according to proper ESD procedures. Laser Safety: Radiation emitted by laser devices can be dangerous to human eyes. Avoid eye exposure to direct or indirect radiation. Legal Notes: IMPORTANT NOTICE! All information contained in this document is subject to change without notice, at LuminentOIC’s sole and absolute discretion. LuminentOIC warrants performance of its products to current specifications only in accordance with the company’s standard one-year warranty; however, specifications designated as “preliminary” are given to describe components only, and LuminentOIC expressly disclaims any and all warranties for said products, including express, implied, and statutory warranties, warranties of merchantability, fitness for a particular purpose, and non-infringement of proprietary rights. Please refer to the company’s Terms and Conditions of Sale for further warranty information. LuminentOIC assumes no liability for applications assistance, customer product design, software performance, or infringement of patents, services, or intellectual property described herein. No license, either express or implied, is granted under any patent right, copyright, or intellectual property right, and LuminentOIC makes no representations or warranties that the product(s) described herein are free from patent, copyright, or intellectual property rights. Products described in this document are NOT intended for use in implantation or other life support applications where malfunction may result in injury or death to persons. LuminentOIC customers using or selling products for use in such applications do so at their own risk and agree to fully defend and indemnify LuminentOIC for any damages resulting from such use or sale. THE INFORMATION CONTAINED IN THIS DOCUMENT IS PROVIDED ON AN “AS IS” BASIS. Customer agrees that LuminentOIC is not liable for any actual, consequential, exemplary, or other damages arising directly or indirectly from any use of the information contained in this document. Customer must contact LuminentOIC to obtain the latest version of this publication to verify, before placing any order, that the information contained herein is current. © LuminentOIC, Inc. 2003 All rights reserved LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 6 LUMNDS1521-FEB1006 rev.A.0