TRUMPower PFC 130 WATT POWER SUPPLIES DESCRIPTION TFC130 SERIES The TFC130 series incorporates creative high efficiency circuitry, high power density (6.94 3 Watts/in ) and active Power Factor Correction (PFC) to meet the requirements of data networking, computing and telecommunication systems. (SINGLE OUTPUT) (LVD) RoHS FEATURES ‧ ‧ ‧ ‧ ‧ ‧ ‧ EN61000-3-2 class A and D compliant Power factor 0.98 typical Very compact size, 3″×5″×1.2″ Overvoltage protections Short circuit protections Remote sense Compliant with RoHS requirements INPUT SPECIFICATIONS Safety Standard Approvals： Input voltage： Input frequency： Input current： 90 to 264VAC 47 to 63Hz 2.1A（ rms） max. for 115VAC 1.1A（ rms） max. for 230VAC Earth leakage current: 0.3mA max. @ 115VAC, 60Hz (Touch current) 0.6mA max. @ 230VAC, 50Hz UL 60950-1 CSA C22.2 No. 60950-1 TÜV EN60950-1 OUTPUT SPECIFICATIONS Output voltage/current： See Rating Chart Ripple and noise： 2% peak to peak on 5.1V model 1% peak to peak on other models. Overvoltage protection： Provided on output set at 112–132% of its nominal output voltage Overcurrent protection： Protected to short circuit conditions Temperature coefficient：All outputs ± 0.04%/ºC maximum Transient response： Maximum excursion of 4% or better on all models; recovering to 1% of final value within 500µs after a 25% step load change ENVIRONMENTAL SPECIFICATIONS Operating temperature： Storage temperature： Relative humidity： Derating： Cooling： -10ºC to +60ºC -40ºC to +85ºC 5% to 95% non-condensing Derate from 100% at +40ºC linearly to 50% at +60ºC 10 CFM total forced air from two 40mm diameter fans or the like is required and provided by user GENERAL SPECIFICATIONS Switching frequency： 110KHz ±15KHz Power factor： 0.98 typical Efficiency： 72% typical on 5.1V output, 76% typical on other outputs Hold-up time： 15 msec minimum at 115VAC Line regulation： ±0.5% maximum at full load Inrush current： 35 amps @ 115VAC or 70 amps @ 230VAC at 25ºC cold start Withstand voltage： 3000VAC from input to output 1500VAC from input to ground 500VAC from output to ground MTBF： 200,000 hours minimum EMC Performance (EN55024) EN55022: FCC Part 15 VCCI: EN61000-3-2: EN61000-3-3: EN61000-4-2: EN61000-4-3: EN61000-4-4: EN61000-4-5: EN61000-4-6: EN61000-4-8: EN61000-4-11: Class B conducted, class A radiated Class B conducted, class A radiated Class B conducted, class A radiated Harmonic distortion, class A and D Line flicker ESD, ±8KV air and ±4KV contact Radiated immunity, 3V/m Fast transient/burst, ±1KV Surge, ±1KV diff, ±2KV com. Conducted immunity, 3Vrms Magnetic field immunity, 1A/m Voltage dips, 30% reduction for 500ms and >95% reduction for 10ms Tumbler Technologies + TRUMPower 3350 Scott Blvd., Bldg. 13, Santa Clara, California 95054, USA Phone: 408-988-6616 ● Fax: 408-988-6622 ● email: [email protected] ● Website: www.TRUMPower.com UNIVERSAL INPUT TFC130 SERIES OUTPUT VOLTAGE/CURRENT RATING CHART Output Product No. Vnom. Imin. Imax. Tol. Maximum Output Power TFC130-S5.1 TFC130-S12 TFC130-S15 TFC130-S18 TFC130-S24 TFC130-S30 TFC130-S36 TFC130-S48 5.1V 12V 15V 18V 24V 30V 36V 48V 0.7A 0.5A 0.5A 0.5A 0.4A 0.4A 0.3A 0.3A 25.5A 10.8A 8.7A 7.2A 5.4A 4.3A 3.7A 2.7A 2% 2% 2% 2% 2% 2% 2% 2% 130W 130W 130W 130W 130W 130W 130W 130W NOTES: 1. 130 watts maximum at 10 CFM forced air cooling. 2. Ripple and noise is measured peak to peak across a 20MHz bandwidth by using a 12 inch twisted pair terminated with a 10uF tantalum capacitor in parallel with a 0.1µF ceramic capacitor. 3. Suffix codes for over-temperature protection function and output connector are as follows. TFC130-X1 X2 X3, where “X1” is the product code from the above table, “X2” is the over-temperature protection function (Blank=without over-temperature protection, W=with over-temperature protection), “X3” is output connector (Blank=Molex KK type, T=miniature terminal blocks), e.g. TFC130-S24-W (24V output voltage, with over-temperature protection, Molex KK type). MECHANICAL SPECIFICATIONS NOTES: 1. Dimensions shown in inch [mm] 2. Tolerance 0.02 [0.5] maximum 3. Connector P1 mates with Molex housing 09-50-3031 and Molex 2878 series crimp terminal. 4. Molex KK type connectors: Connector P3 mates with Molex housing 09-50-3101 and Molex 2878 series crimp terminal. 5. Miniature terminal blocks: Connector P3 are suitable for AWG#18~AWG#12 electric wires. 6. Connector P2, P4 mates with Molex housing 22- 01-1023 and Molex 40445 series crimp terminal. 7. Weight: 0.38 kgs (0.84 lbs.) approx. 8. Potentiometer (VR1) is for output voltage adjustment. PIN CHART CONN P1 P2 Void Void 1 Product No. TFC130-S5.1 TFC130-S15 TFC130-S24 TFC130-S36 TFC130-S12 TFC130-S18 TFC130-S30 TFC130-S48 2 3 1 2 AC AC Void +SENSE -SENSE LIVE NEUTRAL 1 2 3 4 3 4 P3 Void Void 5 OUTPUT 6 P4 7 8 7 8 Void Void 9 RETURN 10 1 2 FAN RET. (12V) Tumbler Technologies + TRUMPower 3350 Scott Blvd., Bldg. 13, Santa Clara, California 95054, USA Phone: 408-988-6616 ● Fax: 408-988-6622 ● email: [email protected] ● Website: www.TRUMPower.com