4PH SINGLE-PHASE FULL WAVE BRIDGE 4 AMPERES FOR P.C. BOARD AND HEAT SINK MOUNTING one omp c e er th und s, inc. n o i t i tor e gni eco Labora r s te ters i dica k in nderwr r a m of U s i Th ram prog PRV/Leg Type No. 50V 4PH05 100V 200V 400V 600V 800V 1000V 4PH10 4PH20 4PH40 4PH60 4PH80 4PH100 nt ELECTRICAL CHARACTERISTICS PER LEG (at TA =25 C Unl es s Oth erw ise Spe ci fie d) 4 Amp Max.Forward Voltage Drop,VF = 1.0V @ IF = 2.5 Amp Max.DC Reverse Current @ PRV,and 25 C , IR 10 A Max.DC Reverse Current @ PRV,and 100 C ,IR 300 A Max.Peak Surge Current, I FSM (8.3ms) (Fig.2) 150 Amp O Average Output Current, Io @ 65 C Tc (Fig.1) Ambient Operating Temperature Range,TA -55 to+150 Storage Temperature Range,TSTG -55 to+150 o C o C Note 1:Derate IO by 20% for capacitive loads EDI reserves the right to change these specifications at any time without notice. 4PH FIG.2 NON-REPETITIVE SURGE CURRENT FIG.1 CURRENT DERATING 1000 BRIDGE OUTPUT RES.-IND. LOADS MAX. PEAK SURGE CURRENT I FSM lO.AVERAGE L FORWARD CURRENT(AMP) 6 Derate current by 20% for capacitive loads 4 65 O HEAT SINK MOUNTING TC TL 2 65 O PC BOARD MOUNTING WITH 3/8 " LEADS 500 200 100 50 20 10 0 0 25 50 75 100 125 150 1 2 5 10 20 50 100 NUMBER OF CYCLES AT 60 CPS O TEMPERATURE ( C) FIG.3 MECHANICAL CASE STYLE FOR 4PH Dielectric test voltage 2,500 V rms., max. 50-60 Hz .280 .935 .260 .895 .185 .160 .165 .140 45 .085 .065 .700 .660 .760Max. .075 R.Typ. .455 (2 Places) .405 1.0Min .260 .180 .220 .180 .205 .185 .052 .048 Dielectric test voltage 2,500 V rms., max. 50-60 Hz NOTE Maximum lead and terminal temperature for soldering, 3/8 inch from case, 5 seconds at 250 C ELECTRONIC DEVICES, INC. DESIGNERS AND MANUFACTURERS OF SOLID STATE DEVICES SINCE 1951. 21 GRAY OAKS AVENUE * YONKERS. NEW YORK 10710 914-965-4400 Ee-mail:[email protected]:http://www.edidiodes.com * * FAX 914-965-5531 * 1-800-678-0828