Oscilent Corporation RF SAW Filter | 801-RF1575.42M-D Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 801-RF1575.42M-D 2.5 x 2.0 SMD GPS Mar. 14, 2007 . TYPE : GPS, RF SAW Filter PART NUMBER : 801-RF1575.42M-D .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Attenuation: Condition Minimum Typical Maximum Units - - 1575.42 - MHz 1574.42~ 1576.42 MHz - 1.0 1.5 dB DC~ 1429.0 MHz 19 21 - 1429.0~ 1501.0 MHz 23 26 - 1501.0~ 1526.0MHz 20 25 - 1625.0~ 1650.0 MHz 15 30 - 1650.0~ 2200.0 MHz 21 25 - 2200.0~ 2500.0 MHz 21 25 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm VSWR 1574.42~ 1576.42 MHz - 1.1 1.5 - Amplitude Ripple 1574.42~ 1576.42 MHz - 0.1 0.5 dBp-p Maximum DC Voltage - - - 7.5 V Maximum Input Power - - - 20 dBm Operating Temperature - -40 - +85 ºC * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C Out D Ground dB Oscilent Corporation RF SAW Filter | 801-RF1575.42M-D Load/ Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Page 2 of 3 Oscilent Corporation RF SAW Filter | 801-RF1575.42M-D Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 801-RF1575.42M-D