Oscilent Corporation RF SAW Filter | 802-RF481.2M-A Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 802-RF481.2M-A 3.0 x 3.0 SMD CDMA450(F-Band) Mar. 2, 2007 . TYPE : CDMA450, RF-Tx SAW Filter PART NUMBER : 802-RF481.2M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Condition Minimum Typical Maximum Units - - 481.2 - MHz 479.0~ 483.5 MHz - 2.0 3.2 dB 0.3~ 467.0 MHz 25 28 - 489.0~ 493.5 MHz 30 50 - 493.5~ 1700.0MHz 23 27 - 1700.0~ 2000.0 MHz 15 22 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm 479.0~ 483.5 MHz - 1.3 2.0 - Maximum Input Power - - - 30 dBm Operating Temperature - -30 - +80 ºC Stop Band Attenuation: VSWR * No Matching Network . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE Source/ Load Impedance = 50 ohms FREQUENCY RESPONSE A Ground B Out C Ground D Ground E In F Ground dB Oscilent Corporation RF SAW Filter | 802-RF481.2M-A Page 2 of 2 VSWR SMITH CHART Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 802-RF481.2M-A