Oscilent Corporation RF SAW Filter | 802-RF1220.0M-C Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 802-RF1220.0M-C 3.0 x 3.0 SMD RF Band Pass Jan. 01, 2007 . TYPE : RF Band Pass SAW Filter PART NUMBER : 802-RF1220.0M-C .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Stop Band Attenuation: Amplitude Ripple Source Impedence (single ended)* Condition Minimum Typical Maximum Units - - 1220.0 - MHz 1210.0~ 1230.0 MHz - 2.7 4.5 dB 1176.0 MHz 40 48 - 1320.0~1360.0 MHz 40 55 - 1210.0~ 1230.0 MHz - 0.5 2.0 dBp-p - - 50 - ohm ohm dB - - 50 - 1210.0~ 1230.0 MHz - 1.3 2.0 - Maximum DC Voltage - - - 5 V Maximum Input Power - - - 15 dBm Operating Temperature - -30 - +85 ºC Load Impendance (single ended)* VSWR * No Matching Network (Ref. Testing Environment Circcuit as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE Load/ Source Impedance = 50ohms A Ground B Out C Ground D Ground E In F Ground Oscilent Corporation RF SAW Filter | 802-RF1220.0M-C FREQUENCY RESPONSE VSWR SMITH CHART Page 2 of 3 Oscilent Corporation RF SAW Filter | 802-RF1220.0M-C Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 802-RF1220.0M-C