Oscilent Corporation RF SAW Filter | 802-RF853.5M-A Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 802-RF853.5M-A 3.0 x 3.0 SMD Wireless Jan. 01, 2007 . TYPE : RF SAW Filter for Wireless Communication PART NUMBER : 802-RF853.5M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Condition Minimum Typical Maximum Units - - 853.5 - MHz 851~ 856 MHz - 2.5 4.0 dB D.C,~ 810.0 MHz 50 60 - 810.0~830.0 MHz 42 47 - 895.0~ 915.0MHz 26 30 - 915.0~ 1500.0 MHz 50 58 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm VSWR 851.0~ 856.0 MHz - 1.4 2.0 - Amplitude Ripple 869.0~ 894.0MHz - 0.3 2.0 dBp-p Maximum DC Voltage - - - 5 V Maximum Input Power - - - 15 dBm Operating Temperature - -15 - +65 ºC Stop Band Attenuation: dB * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B Out C Ground D Ground E In F Ground Oscilent Corporation RF SAW Filter | 802-RF853.5M-A Load/ Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Page 2 of 3 Oscilent Corporation RF SAW Filter | 802-RF853.5M-A Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 802-RF853.5M-A