Oscilent Corporation RF SAW Filter | 803-RF425.0M-C Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 803-RF425.0M-C 3.8 x 3.8 SMD Wireless Jan. 01, 2007 . TYPE : Wireless RF SAW Filter PART NUMBER : 803-RF425.0M-C .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Condition Minimum Typical Maximum Units - - 425.0 - MHz 420.0 ~ 430.0 MHz - 2.5 3.5 dB Fo-47.8 ~ Fo-37.8 MHz 55 59 - Fo+37.8 ~ Fo+47.8 MHz 40 43 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm Amplitude Ripple 420.0 ~ 430.0 MHz - 0.6 1.5 dBp-p VSWR 420.0 ~ 430.0 MHz - 1.5 2.0 - Maximum Input Power - - - 0 dBm Maximum DC Voltage - - - 10 V Operating Temperature - -10 - +50 ºC Attenuation: dB * No Matching Network (Ref. Testing Environment Circuit as shown) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C Ground D Ground E Out F Ground Oscilent Corporation RF SAW Filter | 803-RF425.0M-C Source/ Load Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Page 2 of 3 Oscilent Corporation RF SAW Filter | 803-RF425.0M-C Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 803-RF425.0M-C