Oscilent Corporation IF SAW Filter | 813-SL140.0M-10 Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 813-SL140.0M-10 13.3 x 6.5 SMD Base Station & Repeater Apr 18, 2007 . TYPE : 140.0 MHz Bandpass Filter Low Loss PART NUMBER : 813-SL140.0M-10 .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 139.6 140.0 140.4 MHz Insertion Loss at Fo - 10.5 11.5 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Bandwidth at -1.5 dB 8.9 9.3 - MHz Bandwidth at -3.0 dB 9.0 9.9 - MHz Bandwidth at -35.0 dB - 13.5 14.5 MHz Center Frequency - Relative Attenuation: from 10 to 132 MHz 40 48 - dB from 149 to 260 MHz 40 45 - dB dBp-p Amplitude Ripple within fo +/- 3.6MHz - 0.6 1.0 Group Delay Variation (Fo +/- 3.6MHz) - 100 150 nsec Absolute Delay at Fo - 1.03 - µsec Temperature Coefficient - -94 - ppm/°C In/Out Return Loss at Fo - - - dB *With Matching Network (Reference Testing Environment Circuit as shown) Modifiy Impedance Values as necessary. . PACKAGE OUTLINE (mm) TEST FIXTURE Oscilent Corporation IF SAW Filter | 813-SL140.0M-10 Page 2 of 2 PIN Descriptions IN-11,OUT-5,GROUND-1,2,3,4,6,7,8,9,10,12 FREQUENCY RESPONSE Part No.: 813-SL140.0M-10 Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map