Oscilent Corporation IF SAW Filter | 813-SL60.0M-11 Page 1 of 3 IF SAW Filter Part Number Package Application Last Modified 813-SL60.0M-11 13.3 x 6.5 SMD IF SAW Filter Jan 01, 2007 TYPE : 60.0MHz IF SAW Filter PART NUMBER : 813-SL60.0M-11 OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units Center Frequency (Fo) - 60.0 - MHz Insertion Loss at Fo - 11.8 13.0 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Temperature Coefficient - -94 - ppm/C - 0.4 1.0 dBp-p 10.0 12.0 - MHz Amplitude Ripple (Fo+/-5 MHz) 1dB Bandwidth - Relative Attenuation: Fo+/-4.75 MHz - 0 - dB Fo+/-5.54 MHz - 0 - dB Fo+/-9.75 MHz 40 45 - dB Fo+/10MHz 40 48 - dB Fo+/-20 MHz 45 55 - dB From DC to Fo 14.75 MHz 40 45 - dB From Fo+14.75 to 120MHz 40 45 - dB Absolute Delay at Fo - 1.1 - us Group Delay Variation (Fo+/-5MHz) - 38 70 ns Operating Temp -45 - +85 C Storage Temp -45 - +85 C *With Matching Network (Ref. Testing Environment Circuit as Shown Below). Those impedances could be modified with different impedance values and/or structures, if necessary PACKAGE OUTLINE (mm) Oscilent Corporation IF SAW Filter | 813-SL60.0M-11 TEST CIRCUIT TEST FIXTURE AND VALUES/SOURCE AND LOAD IMPEDANCE 50 ohm INPUT: L1: 270 nH Q>40 OUTPUT: L2: 220 nH Q>40 FREQUENCY RESPONSE Page 2 of 3 Oscilent Corporation IF SAW Filter | 813-SL60.0M-11 Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 813-SL60.0M-11