Oscilent Corporation IF SAW Filter | 835-IF240.0M-D Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 835-IF240.0M-D 35.0 x 12.8 Thru Hole Base Station & Repeater Jan. 01, 2007 TYPE : 240.0 MHz Bandpass Filter PART NUMBER : 835-IF240.0M-D OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 239.85 240.00 240.15 MHz Insertion Loss - 29.5 31.5 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm 1.5dB Bandwidth 13.9 14.12 - MHz 3.0dB Bandwidth 14.1 14.32 - MHz 40.0dB Bandwidth - 15.52 15.8 MHz Amplitude Ripple (Fo+/-6.875 MHz) - 0.9 1.5 dBp-p Group Delay Variation (Fo+/-6.875 MHz) - 65 120 ns Absolute Delay at Fo - 3.18 - µs Ultimate Rejection - 52 - dB Center Frequency - -20 - ppm/°C Storage Temperature -40 - +85 °C Operating Temperature -30 - +70 °C Temperature Coefficient * with Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with different impedances values and/or structures, if necessary. ** Custom SAW IF Filters available. Contact Oscilent for assistance. PACKAGE OUTLINE (mm) Oscilent Corporation IF SAW Filter | 835-IF240.0M-D Page 2 of 2 PIN Descriptions: IN-1, OUT 5, GROUND -2,3,4,6,Case TEST ENVIRONMENT Source & Load Impedance: 50 ohm FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 835-IF240.0M-D