1.6X0.8mm SMD CHIP LED LAMP AP1608SEC SUPER BRIGHT ORANGE Features Description •1.6mmX0.8mm SMT LED, 1.1mm THICKNESS. The Super Bright Orange device is made with DH •LOW POWER CONSUMPTION. InGaAlP (on GaAs substrate) light emitting diode chip. •W IDE VIEW ING ANGLE. •IDEAL FOR BACKLIGHT AND INDICATOR. •VARIOUS COLORS AND LENS TYPES AVAILABLE. •PACKAGE: 2000PCS / REEL . •RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.1(0.004") unless otherwise noted. 3.Specifications are subject to change without notice. SPEC NO: DSAD0918 REV NO: V.2 DATE: MAR/10/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203000055 Selection Guide Part No. Dice SUPER BRIGHT ORANGE (InGaAlP) AP1608SEC Iv (mcd) @ 20mA Lens Type Viewing Angle Min. Typ. 2θ θ1/2 70 200 120° WATER CLEAR Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Super Bright Orange λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 610 nm IF=20mA Super Bright Orange 601 nm IF=20mA Spectral Line Half-width Super Bright Orange 29 nm IF=20mA C Capacitance Super Bright Orange 30 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Orange 2.0 2.5 V IF=20mA IR Reverse Current Super Bright Orange 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Orange Units Power dissipation 75 mW DC Forward Current 30 mA Peak Forward Current [1] 195 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD0918 REV NO: V.2 DATE: MAR/10/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203000055 Super Bright Orange AP1608SEC SPEC NO: DSAD0918 REV NO: V.2 DATE: MAR/10/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203000055 AP1608SEC Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength) , the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAD0918 REV NO: V.2 DATE: MAR/10/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203000055