Oscilent Corporation RF SAW Filter | 803-RF930.5M-A Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 803-RF930.5M-A 3.8 x 3.8 SMD Wireless Communication Sept. 03 2003 . TYPE : 930.5 MHz RF Low Loss SAW Filter PART NUMBER : 803-RF930.5M-A . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Condition Minimum Typical Maximum Units - - 930.5 - MHz 928.5 ~ 932.5 MHz - 2.2 3.0 dB DC Voltage - - - 5 V Input Power - - - 15 dBm Operating Temperature - -30 - +65 °C Storage Temperature - -40 - +85 °C Center Frequency (Fo) Insertion Loss Ripple Stopband Attenuation VSWR Teminating Impedance 928.5 ~ 932.5 MHz - 0.3 1.0 dB Fo -200.0 ~ Fo -40.8 MHz 50.0 55.0 - dB Fo +50.0 ~ Fo +200.0 MHz 40.0 48.0 - 928.5 ~ 932.5 MHz - 1.4 2.0 - - - 50 - ohm * Maximum Rating (Ta=25°C) ** Custom SAW RF Filters available. Contact Oscilent for assistance. . Pin Layout A Ground B Input C Ground D Ground E Output F Ground Frequency Reponse http://www.oscilent.com/spec_pages/rf_sawfilter/rf_803_rf930_5a.htm 12/28/2005 Oscilent Corporation RF SAW Filter | 803-RF930.5M-A Page 2 of 2 VSWR (S11, S22) Smith Chart Oscilent Corporation - CALL 949.252.0522 17962 Sky Park Circle . Building D . Irvine . CA 92614 . USA Fax: 949.252.0599 . E-Mail: [email protected] Part No.: 803-RF930.5M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/rf_sawfilter/rf_803_rf930_5a.htm 12/28/2005