RADIO FREQUENCY IDENTIFICATION SYSTEMS Data Sheet Mount-on-Metal Transponder Specifications: Part Number RI-TRP-R9VS RI-TRP-W9VS Functionality Read Only Read/Write Memory (Bits) 64 80* Memory (Pages) 1 1 Operating Frequency 134.2 kHz Modulation FSK (Frequency Shift Keying) 134.2 kHz / 123.2 kHz Transmission Principle HDX (Half Duplex) Power Source Powered from the reader signal (batteryless) Typical Reading Range ≤ 120 cm** Typical Programming Range --- Typical Reading Time 70 ms Typical Programming Time --- 309 ms Typical Programming Cycles --- 100,000 Operating Temperature -25 to +70°C*** Storage Temperature -25 to +85°C Case Material Polypropylene, black Protection Class IP 67 ( product revision –11 ) Mounting With screws or rivets on aluminum, iron or steel 30 % of typical reading range EMC Programmed code is not affected by normal electromagnetic interference or x-rays Signal Penetration Transponder can be read through virtually all non-metallic material Mechanical Shock IEC 68-2-27, Test Ea; 200 g, half sine, 3 ms, 3 axes, 6 shocks per axis Vibration IEC 68-2-6, Test Fc; 20 g, 20 - 500 Hz, 3 axes, 10 cycles per axis Dimensions 102 mm ± 1 mm * 36 mm ± 1 mm * 16.5 mm ± 1 mm Weight 43 g * We recommend that you split each 80 bit page into 64 user programmable bits plus a 16 bit wide CRC CCITT Block Check Character as is done by TI-RFID LF readers. ** Depending on RF regulation in country of use, the Reader Antenna configuration used, and the environmental conditions. *** Reduced operating temperature of 0 to +70°C if used with Series 2000 Standard Reader (RI-STU-MB2A/MB6A) or Standard RFM (RI-RFM-104B) For more information, contact the sales office or distributor nearest you. This contact information can be found on our web site at: http://www.ti-rfid.com Texas Instruments reserves the right to change its products and services at any time without notice. TI provides customer assistance in various technical areas, but does not have full access to data concerning the uses and applications of customers products. Therefore, TI assumes no responsibility for customer product design or for infringement of patents and/or the rights of third parties, which may result from assistance provided by TI. © Copyright 2001 Texas Instruments Incorporated. Data Sheet: 11-09-22-065 07/01