Tyco/Electronics PRODUCT: RXE010S Raychem Circuit Protection 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 Fax: 800-227-4866 PolySwitch® PTC Devices DOCUMENT: SCD 23913 PCN: 338893 REV LETTER: E REV DATE: AUGUST 20, 2001 PAGE NO.: 1 OF 1 Overcurrent Protection Device Specification Status: RELEASED Electrical Rating Voltage: 60V MAX Current: 40A MAX Insulating Material: Cured, Flame Retarded Epoxy Polymer meets UL94 V-0 Requirements Lead Material: 24 AWG Solder coated nickel-copper alloy Marking: Voltage 60 X 01 0 Part Identification Lot Identification (can be on back) TABLE I. DIMENSIONS: A B C D E F MIN MAX MIN MAX MIN MAX MIN MAX MIN MAX TYP mm: -8.9 -11.2 4.3 5.8 7.6 --3.0 -in*: -(0.35) -(0.44) (0.17) (0.23) (0.30) --(0.12) -*Rounded off approximation TABLE II. PERFORMANCE RATINGS: IH TIME TO INITIAL ONE-HOUR POST-TRIP NOMINAL RATED TRIP RESISTANCE RESISTANCE TRIPPED STATE CURRENT CURRENT RATINGS VALUES STANDARD TRIP POWER DISSIPATION AMPERES AMPERES AMPERES AMPERES SECONDS AT OHMS OHMS WATTS AT 20°C AT 0°C AT 20°C AT 60°C 20°C, 0.5A AT 20°C AT 20°C 20°C HOLD HOLD TRIP HOLD TRIP HOLD TRIP MAX MIN MAX MAX NOMINAL .10 .11 Recognitions: Reference Documents: Precedence: Effectivity: CAUTION: .22 .10 .20 .07 .14 4.0 2.50 4.50 7.5 .38 UL, CSA and TUV approved. Approved by UL as a current limiting impedance, per the 1996 NEC, Tables 11 (c) and 11 (b). PS300 This specification takes precedence over documents referenced herein. Reference documents shall be the issue in effect on the date of invitation for bid. Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame.