CYPRESS CONFIDENTIAL PRELIMINARY CYONS1001L OvationONS™ 1L - Laser Navigation Sensor Features Applications • Laser Sensor • Laser mice — New OptiCheck technology • Optical trackballs — Selectable resolution 400, 800, and 1200 cpi • Motion sensing applications — High speed motion detection (20 in/s Typ; 8G Typ) Functional Description — Wide operating voltage: 2.7V to 3.6V — Self adjusting power saving modes The CYONS1001L is a two piece kit containing: — Self adjusting frame rate for optimum performance 1. An IC package (with 2 kV ESD) that integrates: — Motion detect pin output a. Laser Detector analog and digital circuitry — Internal oscillator — no crystal required b. VCSEL c. Optical aperture — 4-Wire SPI port 2. A molded plastic piece containing a lens for collimation of the VCSEL beam and for imaging of the light scattered from the tracking surface onto the sensor portion of the laser detector. The molded optic has features for registration to the package and attachment to the PC board. — Fault tolerant laser drive circuitry on chip for eye safety compliance — Minimum number of passive components • Vertical Cavity Surface Emitting Laser (VCSEL) Figure 1. CYONS1001L (Two Piece System) — Integrated within the sensor package — Optical power: Typ 0.520 mW at room temperature* — Wavelength: 850 nm Typ. (840 nm min., 870 nm max.)* • * Class-1 Laser products per IEC60825-1/A2: 2001 and EN 10 60825-1/A1: 2002, with optical output power < 0.743 mW over all specified operating temperatures and supply voltages, and with emission wavelength between 840 and 870 nm • Molded Optic — 12.78 mm distance from PCB to tracking surface 5.4 8.3 Block Diagram Figure 2. CYONS1001L Chip AVDD AGND NCS SCK MISO SPI Oscillator Detector MOSI MOTION DSP Sensor Core VCSEL Driver SHUTDOWN VCSEL DVDD Cypress Semiconductor Corporation Document #: 001-09868 Rev. *A • DGND 198 Champion Court • San Jose, CA 95134-1709 • 408-943-2600 Revised April 03, 2007 [+] Feedback CYPRESS CONFIDENTIAL PRELIMINARY CYONS1001L When operated within the recommended operating conditions, (25°C; 3.3V) the sensor has this tracking performance: Functional Overview The CYONS1001L is a complete laser navigation sensor. It resides on a printed circuit board within an optical solution. The CYONS1001L supplies all illumination and optical navigation functions to provide position change data. The CYONS1001L tracks on wide range of surfaces. The device also provides these functions: Parameter Resolution Min. Typ. Max. Unit 400 800 1200 cpi Speed 20 in/s • SPI interface to USB microcontroller or wireless transmitter Acceleration 8 G • Internal system clock Lift sense height • Fault tolerant laser power control meeting IEC 60825 class 1 eye safety requirements 2.8 mm Tracking error 5 % Zero motion 1 count Pin Descriptions[1, 2] Pin QFN Signal Name Type # Of Pins I 1 Function 14 NCS (Chip Select) SPI chip select 11 SCK (Serial Clock) I 1 SPI clock input 10 MISO (Master In/Slave Out) O 1 SPI output 15 MOSI (Master Out/Slave In) I 1 SPI input 20 SHUTDOWN I 1 Enter Hibernate mode 21 MOTION O 1 Motion detect; active LOW output 28 EXTCFG I 1 External configuration for factory test 26 AVDD Power 1 Analog supply voltage 2, 4, 9 DVDD (Regulator Power) Power 3 Digital supply voltage 25 AGND Ground 1 Analog ground 3, 30, Case bottom GND Ground 1 Digital ground 5, 6, 7, 8, 9, 12, 13, 16, 17, 18, 19, 22, NC 23, 24, 27, 31,32, 33, 34, 36, 37, 38, 39 23 No connect 1, 35, 40, 41, 42 5 Tie to GND Tie to DGND Notes 1. SPI pin assignment assumes CYONS1001L is in SPI slave mode. 2. See ““Power Supply Connections” on page 4” for power and ground pin configurations. Document #: 001-09868 Rev. *A Page 2 of 9 [+] Feedback DGND DVDD DGND DVDD CYONS1001L DGND DGND DGND 35 42 41 40 DGND CYPRESS CONFIDENTIAL PRELIMINARY 1 2 3 4 30 DGND 29 DVDD 28 EXTCFG CYONS1001L Document #: 001-09868 Rev. *A MOTION 20 21 14 15 NCS MOSI SHUTDOWN 10 11 MISO SCK 26 AVDD 25 AGND Page 3 of 9 [+] Feedback CYPRESS CONFIDENTIAL PRELIMINARY CYONS1001L Power Supply Connections Power 3 ohms 2 4 DVDD 29 26 AVDD 22 µF CYONS1001L GND DGND 3 30 AGND 25 Ground Note Additional power supply connections, setups, and specifications are documented in the CYONS1001L User Guide. Document #: 001-09868 Rev. *A Page 4 of 9 [+] Feedback CYPRESS CONFIDENTIAL PRELIMINARY CYONS1001L Absolute Maximum Ratings Parameter Min Typ Max Unit Notes Storage Temperature –40 85 °C Case temperature Operating Temperature –15 55 °C Case temperature 260 °C 10 seconds –0.5 (tbd) 3.7 (tbd) V 2 kV –0.5 Vdd + 0.5 V 100 mA Lead Solder Temperature Supply Voltage ESD Input Voltage Latch Up Current All pins, HBM MIL 883 method 3015 Operating Conditions Parameter Max Unit 5 45 °C Power Supply Voltage 2.7 3.6 Power Supply Rise Time 100 Operating Temperature Min Typ Notes V µs Supply Noise—AVDD (sinusoidal) 25 mV p-p 10 kHz–50 MHz Supply Noise—VDD, DVDD (sinusoidal) 100 mV p-p 10 kHz–50 MHz Serial Port Clock Frequency 2.0 MHz Active drive, 50% duty cycle Distance from Lens to Surface Plane 12.53 2.78 13.03 mm Deviation from nominal will adversely impact lift detection. Distance from PCB to Tracking Surface 12.55 12.8 13.05 mm 100 pF Typ Max Unit DC Supply Current (track mode) 12.4 15.5 mA DC Supply Current (nap1 mode) 5.4 7.7 mA Load Capacitance MOTION, MISO DC Electrical Characteristics Parameter Min DC Supply Current (nap2 mode) 1.9 3.9 mA DC Supply Current (sleep mode) 250 380 µA Hibernate Supply Current 45 100 µA 0.8 V Input Low Voltage Input High Voltage 0.7Vdd V Input Hysteresis 100 Input Leakage Current ±1 Output Low Voltage Output High Voltage Input Capacitance Document #: 001-09868 Rev. *A Notes mV ±10 µA MOSI, NCS 0.7 V MISO, MOTION 10 pF Vdd – 0.7 V MOSI, NCS Page 5 of 9 [+] Feedback CYPRESS CONFIDENTIAL PRELIMINARY CYONS1001L AC Electrical Characteristics Parameter Min Typ Max Unit Notes Motion Delay after Reset 100 ms Hibernate 50 ms 100 ms 300 ns 100 pF load 300 ns 100 pF load 120 ns Wake from Hibernate MISO Rise Time 150 MISO Fall Time 150 MISO Delay after SCLK MISO Hold Time 0.5 µs MOSI Hold Time 200 ns MOSI Setup Time 120 ns SPI Time between Write to Register 30 µs SPI Time between Write to and Read from Registers 20 µs SPI Time between Read and Subsequent Reads 400 µs SPI Delay from Last Address Bit to First Data Bit Out 4 µs NCS Inactive after Burst Register Access 500 ns NCS to SCLK Active 120 ns SCLK to NCS Inactive (for read) 120 ns SCLK to NCS Inactive (for write) 20 From command to low current µs NCS to MISO High Z 500 ns 5 pF load, Thevenin load MOTION Rise Time 150 300 ns 100 pF load MOTION Fall Time 150 300 ns 100 pF load tbd mA Max supply current during input voltage ramp Transient Current Supply Ordering Information Part Number Description CYONS1001L-LBXC Sensor in PQFN Package Part Number Description CYONSLENS1001-C Lens Document #: 001-09868 Rev. *A Package Type Operating Range PQFN = Plastic Quad Flat (No Lead) 5–45°C Package Type Operating Range 5–45°C Page 6 of 9 [+] Feedback CYPRESS CONFIDENTIAL PRELIMINARY CYONS1001L Package Diagrams Figure 3. Mechanical and LAND Pads Dimensions Figure 4. Molded Optic Document #: 001-09868 Rev. *A Page 7 of 9 [+] Feedback CYPRESS CONFIDENTIAL PRELIMINARY CYONS1001L Package Diagrams (continued) Figure 5. PCB Mounting Height (Side View) PCB PACKAGE MOLDED OPTIC 12.78 mm Tracking Surface 2.78mm This document is subject to change without notice, and may contain errors of omission or changes in parameters. OvationONS and OptiCheck are trademarks of Silicon Light Machines (a subsidiary of Cypress Semiconductor). Document #: 001-09868 Rev. *A Page 8 of 9 © Cypress Semiconductor Corporation, 2006-2007. The information contained herein is subject to change without notice. Cypress Semiconductor Corporation assumes no responsibility for the use of any circuitry other than circuitry embodied in a Cypress product. Nor does it convey or imply any license under patent or other rights. Cypress products are not warranted nor intended to be used for medical, life support, life saving, critical control or safety applications, unless pursuant to an express written agreement with Cypress. Furthermore, Cypress does not authorize its products for use as critical components in life-support systems where a malfunction or failure may reasonably be expected to result in significant injury to the user. The inclusion of Cypress products in life-support systems application implies that the manufacturer assumes all risk of such use and in doing so indemnifies Cypress against all charges. [+] Feedback CYPRESS CONFIDENTIAL PRELIMINARY CYONS1001L Document History Page Document Title: OvationONS™ 1L - Laser Navigation Sensor Document Number: 001-09868 REV. ECN NO. Issue Date Orig. of Change ** 498388 07/21/2006 XSY New Data Sheet *A 906600 04/03/2007 XSY Updated DC Characteristics Table Removed 1000 dpi resolution option Document #: 001-09868 Rev. *A Description of Change Page 9 of 9 [+] Feedback