B200SR Description Sensor Sounder Base • The B200SR Series sounder base sets a new standard for performance, installation, and aesthetics. It is a nonaddressable base that is available in both Velociti® and Clip™ protocols. The B200SR is designed for new and existing dwelling unit applications. It offers maximum flexibility in installation, configuration, and operation to comply or exceed the UL® Standard 268 and UL® Standard 464 requirements. The B200SR is fully compatible and is a replacement for the existing B501BH-Series sounder base installations. By removing a jumper, the device enables users to select one of two B501-supported tones (ANSI Temporal 3 or Continuous). With its attractive aesthetics, the B200SR is ideal for use with applications where appearance is critical. For example, the sounder base employs a separate mounting plate that installs on various junction box sizes to eliminate unsightly surface-mount boxes (refer to Table 1). In addition, the mounting plate enables pre-wiring of all connections to simplify the installation. To install the housing, use the mounting plate, and secure two retaining screws to lock-it in position. The retaining screws are covered by the installed sensor head for added tamper resistance. • Specifications B200SR Features • Complies with UL® Standard 268 and UL® Standard 464. • Provides a tone selection via an onboard jumper. Physical Specifications • Offers a pre-wire mounting plate that fits various 6.875” (17.5 cm) 2.0” (5.08 cm) less sensor 0.50 lb. (227 gm) Base Diameter: Base Height: Shipping Weight: Operating Temperature Range: Operating Humidity Range: junction box sizes. • Includes a mechanical locking feature that prevents the 32° to 120° F (0° to 49° C) 10% to 93% relative humidity (non-condensing) removal of the attached sensor head. • Fully compatible with the existing B501BH-Series sounder base installations. • Electrical Specifications External Supply Voltage: Standby Current: Alarm Current: SLC Operating Voltage: SLC Standby Current: Sound Output: 16 to 33 VDC (VFWR) 500 µA maximum 35 mA maximum 15 to 32 VDC 300 µA maximum Greater than 85 dBA minimum – measured in a UL reverberant room at 10 ft. 24 Volts (in continuous tone). Ordering Information Part Number Description B200SR Sensor Sounder Base Note: Use the B200SR with the 7100 Series, 602 Series or Gamewell and FCI (Legacy) panels. • • Table 1: B200SR Junction Box Selection Guide Single Gange Yes 50 mm No 3.5” Octagonal Yes 60 mm No 4.0” Octagonal Yes 70 mm Yes 4.0” Square Yes 4.0” Square w/ 3.0” mud ring Yes 75 mm No UL® is a registered trademark of Underwriters Laboratories Inc. • GAMEWELL-FCI 12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118 Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use. www.gamewell-fci.com 9021-60553 Rev. D page 1 of 1 ©2014 by Honeywell International Inc. All rights reserved.