Preliminary Product Specifications Q22 Series High Power LED Driver Total Power 22 Watts max. Input Voltages 110 ~ 277VAC Number of Outputs One ANZ#: Z220, May 19, 2014 SPECIAL FEATURES Universal Input range from 100VAC~304VAC, 50/60Hz Versatile mechanical design maximizes design flexibility. Size: XP: TBD (LxWxH) Fully potted, suitable for dry and damp location applications 4 in 1 Dimming Control plus “ENABLE” input UL8750 and CE compliant (pending) Wide selection of pre-adjusted C/C outputs (factory setting) Picture Not Available ENVIRONMENTAL Operating temperature: -40 to +50 ⁰ C, Tc: 80 ⁰ C Storage temperature: -40 to +85 ⁰ C Humidity (Non-Condensing): 5% to 95% Cooling: Convection Vibration Frequency: 5 to 50 Hz MTBF: >100,000 Hours at full load and 25ºC ambient conditions (TELC3 – Telcordia SR-332, Issue 3) Picture shown above is not to scale SPECIFICATIONS : Input Range : 100 ~ 277VAC Power Factor: > 0.92 at 65% to 100% load, 115VAC or 230VAC Input Current : 0.3 Amps max. at 115VAC Output Current Regulation : ±3% Protection : OCP, SCP, OLP – Auto Recovery Control : 0-10V dimmer; PWM (250-3KHz); Potentiometer; Enable Hold up time: Half cycle min. at 120VAC and 80% rated load Frequency : 47 to 63Hz Inrush Current : 25.0 Amps max. at 230VAC, cold start 25⁰C Efficiency : 87% Typical Maximum Power : 12W Leakage Current : 50uA typ. Dimension: XP: TBD (LxWxH) Regulation Compliance: UL8750 or EN61347, EN55015, EN61547 MODEL SELECTION : Constant Voltage Mode V (DC) A (mA) Max. W Model Number 12, ±5% Q22-U12-XP 24, ±5% Q22-U24-XP 36, ±5% Q22-U36-XP 48, ±5% Q22-U48-XP Notes: yyyy = Output current 1850 920 610 460 22 22 22 22 Constant Current Mode A (mA) V (DC) Max. W Model Number Q22-U12-Cyyyy-Xz Q22-U24-Cyyyy-Xz Q22-U30-Cyyyy-Xz Q22-U36-Cyyyy-Xz Q22-U42-Cyyyy-Xz Q22-U48-Cyyyy-Xz Q22-U54-Cyyyy-Xz 2500 ~ 1850 1250 ~ 920 1000 ~ 730 825 ~ 610 700 ~ 525 620 ~ 460 550 ~ 400 6 ~ 12 14 ~ 24 19 ~ 30 23 ~ 36 27 ~ 42 30 ~ 48 34 ~ 54 22 22 22 22 22 22 22 Dimming Wiring Diagram 10K ohm (min) potentiometer Maximum current required: 1mA max per LF1048 driver. (+) LED Driver +V out (RED) -V out (BLACK) DIM+ (PURPLE) DIM(GRAY) +10V OUT (YELLOW) DIM+ (PURPLE) DIM(GRAY) NC/CAP +10V OUT (YELLOW) LED Driver +V out (RED) -V out (BLACK) (-) LED Driver +V out (RED) -V out (BLACK) www.magtechind.com Tel: 702‐364‐9998 (+) DIM+ (PURPLE) (-) DIM(GRAY) Typically 6mA. +10V OUT (YELLOW) (+) PWM Controller PWM (250Hz~2KHz) DIM+ (PURPLE) (-) Maximum current output: DIM(GRAY) DIMMER (sinking) DIMMER (sourcing) NC/CAP LED Driver +10V OUT (YELLOW) +V out (RED) -V out (BLACK) 1 of 2 De-rating Temp. vs. Load Efficiency vs. Load Power Factor vs. Load THD vs. Load PWM Dimming Curve 1-10V Dimming Curve MECHANICAL SPECIFICATION : Q38-UXX-XP-CYYYY 4.76 [121.0] Units: IN [mm] 3.46 [88.0] ? .12 [? .0] 4.02 [102.0] 0.20 [5.0] 8-32(x2) 1.18 [30.0] 1.02 [26.0] 1.37 [34.8] 1.61 [41.0] 1.65 [42.0] 3.22 [81.8] 2.00 [50.8] 4.49 [114.0] 1.01 [25.6] 1.14 [29.0] “Xm” – Stud‐mountable Metal Case www.magtechind.com Tel: 702‐364‐9998 0.13 [3.3] Units: IN [mm] “Xp” – Plastic Case 2 of 2