HIGH CURRENT PLANAR TRANSFORMER HP30 SERIES • High Current, Flat Wire Planar Transformer • Superior heat dissipation compared with traditional designs • Rated Power: 500W - 1000W, Full Bridge • Hi-pot: 2.5KVrms (Pri to Sec), 500Vrms (winding to core) • Operating Temperature -40ºC to +130ºC • RoHS Compliant Product • Custom Design Available ELECTRICAL PARAMETERS @ 25°C PART NUMBER OCL (1-2) (µH MIN) LEAKAGE L (1-2) (µH MAX) TURNS RATIO PRI : SEC ±5% DCR (1-2) (mΩ MAX) DCR (3-5) (mΩ MAX) SRF (1-2) (MHz MIN) SEC PINS (mm) HP30-11 5.0 0.5 1:1 1.0 1 2.0 1.20x5.0 HP30-12 5.0 0.5 1:2 1.0 3 2.0 0.60x5.0 HP30-13 5.0 0.5 1:3 1.0 5 2.0 0.55x5.0 HP30-14 5.0 0.5 1:4 1.0 8 2.0 0.40x4.5 HP30-15 5.0 0.5 1:5 1.0 10 2.0 0.40x4.5 HP30-16 5.0 0.5 1:6 1.0 12 2.0 0.35x4.5 Note: 1. Inductance measured at 1MHz, 1Vrms 2. Leakage Inductance measured at 1MHz, 1Vrms (3-5 shorted) 3. Polarity: 1 & 5 are in phase 4. ET Max (1-2): 60V-µS SWITCHING FREQUENCY (KHz) OUTPUT POWER MAX (Watts) INPUT VOLTAGE MAX (V) INPUT CURRENT MAX (A) OUTPUT VOLTAGE VS. CURRENT (V / A) MAX TEMP RISE (ºC) 250 600 50 25 ref Turns Ratio 50 500 960 80 25 ref Turns Ratio 50 1000 1500 120 25 ref Turns Ratio 50 Product performance is limited to specified parameters. Data is subject to change without prior notice. Tel: 310-325-1043 Fax: 310-325-1044 www.mpsind.com [email protected] HIGH CURRENT PLANAR TRANSFORMER HP30 SERIES DIMENSIONS (mm) Product performance is limited to specified parameters. Data is subject to change without prior notice. Tel: 310-325-1043 Fax: 310-325-1044 SCHEMATIC Dimensions Unless otherwise specified, all tolerances are: inch: .XX : ±0.015 .XXX : ±0.005 mm: X,X : ±0,38 X,XX : ±0,13 www.mpsind.com [email protected]