MAGNETIC EPOXY SHIELDED SMT POWER INDUCTOR PSF109 SERIES • Magnetic shielding using magnetic epoxy resin results in lower costs as compared to traditional ferrite shielded inductors • Size: 10.5mm length x 10.3mm width x 10.0mm height • Operating Temperature -40ºC to +120ºC • RoHS Compliant Product • Custom Design Available ELECTRICAL PARAMETERS @ 25°C Part Number PSF109- INDUCTANCE (μH) ±20% Isat (Adc) MAX DCR (Ω) MAX 101M 100 1.54 0.19 121M 120 1.14 0.20 151M 150 1.02 0.22 181M 180 0.94 0.25 221M 220 0.86 0.27 271M 270 0.78 0.39 331M 330 0.72 0.49 391M 390 0.66 0.54 471M 470 0.58 0.68 561M 560 0.52 0.86 681M 680 0.47 1.00 821M 820 0.45 1.10 102M 1000 0.40 1.43 122M 1200 0.37 1.60 152M 1500 0.34 2.10 182M 1800 0.30 2.30 222M 2200 0.20 2.40 Note: 1. Inductance measured at 100KHz, 1Vrms 2. Isat: ∆L drops 30% max from its initial value Product performance is limited to specified parameters. Data is subject to change without prior notice. Tel: 310-325-1043 Fax: 310-325-1044 www.mpsind.com [email protected] MAGNETIC EPOXY COATED SMT POWER INDUCTOR PSF109 SERIES DIMENSIONS (mm) Product performance is limited to specified parameters. Data is subject to change without prior notice. Tel: 310-325-1043 Fax: 310-325-1044 Dimensions Unless otherwise specified, all tolerances are: inch: .XX : ±0.015 .XXX : ±0.004 mm: X,X : ±0,38 X,XX : ±0,10 www.mpsind.com [email protected]