MAGNETIC EPOXY SHIELDED SMT POWER INDUCTOR PSF74 SERIES • Magnetic shielding using magnetic epoxy resin results in lower costs as compared to traditional ferrite shielded inductors • Size: 7.5mm length x 7.0mm width x 4.5mm height • Operating Temperature -40ºC to +120ºC • RoHS Compliant Product • Custom Design Available ELECTRICAL PARAMETERS @ 25°C Part Number PSF74- INDUCTANCE (μH) ±20% Isat (Adc) MAX DCR (Ω) MAX 100M 10 1.84 0.049 150M 15 1.47 0.081 220M 22 1.23 0.11 330M 33 0.96 0.17 390M 39 0.91 0.23 470M 47 0.88 0.26 560M 56 0.75 0.35 680M 68 0.69 0.38 101M 100 0.60 0.61 151M 150 0.46 0.88 181M 180 0.42 0.98 221M 220 0.36 1.17 271M 270 0.34 1.64 331M 330 0.32 1.86 391M 390 0.29 2.85 471M 470 0.26 3.01 102M 1000 0.18 6.00 502M 5200 0.14 20.0 Note: 1. Inductance measured at 100KHz, 0.1Vrms 2. Isat: ∆L drops 25% max from its initial value Product performance is limited to specified parameters. Data is subject to change without prior notice. Tel: 310-325-1043 Fax: 310-325-1044 www.mpsind.com [email protected] MAGNETIC EPOXY COATED SMT POWER INDUCTOR PSF74 SERIES DIMENSIONS (mm) Product performance is limited to specified parameters. Data is subject to change without prior notice. Tel: 310-325-1043 Fax: 310-325-1044 Dimensions Unless otherwise specified, all tolerances are: inch: .XX : ±0.015 .XXX : ±0.004 mm: X,X : ±0,38 X,XX : ±0,10 www.mpsind.com [email protected]