ALUMINUM ELECTROLYTIC CAPACITORS Surface Mount Type Recommended Land Size (mm) Conductive polymer aluminum solid electrolytic capacitors Y a Y X Size X Y a φ4 1.6 2.6 1.0 φ5 1.6 3.0 1.4 φ6.3 1.6 3.5 2.1 φ8 2.0 3.5 3.0 φ 10 2.0 4.0 4.0 Conductive polymer aluminum solid electrolytic capacitors Vibration Resistance Type(CX, CR Series) X Y a 3.0 4.0 1.6 φ8 × 7.5L 4.3 5.3 2.0 φ8 × 10.5L 4.3 5.3 2.0 φ10 × 10.5L 4.3 5.6 3.3 Size φ6.3 × 8L Please refer to page25 about the FPCAP product spec. Soldering by Reflow Table-1 Chip Type Conductive Polymer Aluminum Solid Electrolytic Capacitors Reflow Temperature (˚C) Peak 230 Peak Temp. at Measuring Point ,5s MAX. Pre - heating shall be done at +150˚C to 200˚C and for 60 to 180 seconds. The duration for over +230˚C temperature at capacitor surface shall not exceed 60 seconds. • The standard temperature profile differs by every reflow method. • Peak temp. +260˚C or below : Reflow shall be done 1 cycle only. • Peak temp. +250˚C or below : Reflow shall be done within 2 cycles. • Please make sure the parts have enough cooling down time between the first and second soldering process. • The temperature at capacitor Top shall not exceed the peak temperature. • Please contact us if capacitors are subject to the conditions other than the allowable range at reflow. Please refer to page25, about the FPCAP product spec. • • 175 150 to 200˚C 60 to 180s 0 (CF, CJ, CK, CG, CS, CV, CX, CR) over 230˚C 60s MAX. Time (s) CAT.8100D CONDUCTIVE POLYMER ALUMINUM SOLID ELECTROLYTIC CAPACITORS Recommended Land Size Conductive polymer aluminum solid electrolytic capacitors Y PS, PA, HS, HA, SS, SA, SB, FS, FA, SL series (mm) X Y a φ4 1.6 2.6 1.0 Size a Y FPCAP X φ5 1.6 3.0 1.4 φ6.3 1.6 3.5 2.1 φ8 1.9 4.2 2.8 φ10 1.9 4.4 4.3 Lead free and RoHS directive compliant soldering requirements NS, R7, R5, L8, E5, S8, F8, NU, NE, S6, HT series Recommended Flow Profile Temperature Soldering Within 10sec. Within 120sec. Time (sec) PS, PA, HS, HA, SS, SA, SB, FS, FA, SL series Recommended Reflow Profile Peak Temperature Preheating Time (sec) Item Peak Temperature Preheating Recommended Recommended Condition 1 Condition 2 or less within 90 seconds or less within 90 seconds and higher and higher within 60 seconds within 60 seconds and higher and higher within 40 seconds within 40 seconds The Number of Reflow Only 1 time Twice or less CAT.8100D