PEN5-xxxxE/Z4:1MLF Mainzer Straße 151–153 D-55299 Nackenheim Tel. +49 6135 7026-0 Fax: +49 6135 931070 www.peak-electronics.de [email protected] PEN5-SERIES Rev.05-2009 4-6 Watt 4:1 Ultra Wide Input Reg. Single and Dual Output DIP24 Metal Case 1.5 kV DC I/O Isolation Continuous Short Circuit Prot. All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified Input Specifications Voltage Range Input Filter Input Reflected Ripple Current¹ 4:1 Ultra Wide Input Pi Type 35 mA pk-pk Output Specifications Voltage Accuracy Short Circuit Protection Line Regulation Load Regulation Ripple and Noise (20Mhz bandwidth) Temperature Coefficient ± 1% Indefinite (automatic recovery) ± 0.5% ± 0.5% / ± 1.5% (only 3.3 / ±3.3 Vout Models) 60 mV pk-pk ± 0.02% / °C General Specifications Efficiency I/O Isolation Voltage (3 sec.) I/O Isolation Capacity I/O Isolation Resistance Switching Frequency (typical) Humidity Reliability Calculated MTBF (MIL-HDBK-217F) See Table 1500 VDC 500 pF, typ. 1000 MOhm 266 kHz, typ. 95% rel H > 1.121 Mhrs Physical Specifications Case Material Potting Material Weight Nickel Coated Copper Epoxy (UL94V-0 rated) ~ 17g, typ. Environment Specifications Operating Temperature Maximum Case Temperature Storage Temperature Cooling RoHS Conform -40 to +85°C (ambient) 100°C -40 to +125°C Free Air Convection (10mm distance required) Soldering 260°C, max. (1.5mm from case 10s.) PEN5-Series – PEN5-xxxxE/Z4:1MLF – Single and Dual Output – DIP24 - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 1/3 Selection Guide Single/Dual Output Order # SINGLE OUTPUT PEN5-243R3E4:1MLF PEN5-2405E4:1MLF PEN5-2412E4:1MLF PEN5-2415E4:1MLF PEN5-483R3E4:1MLF PEN5-4805E4:1MLF PEN5-4812E4:1MLF PEN5-4815E4:1MLF DUAL OUTPUT PEN5-2405Z4:1MLF PEN5-2412Z4:1MLF PEN5-2415Z4:1MLF PEN5-4805Z4:1MLF PEN5-4812Z4:1MLF PEN5-4815Z4:1MLF t Wat A) ) m A) d (m mA) ad (mA ( a ad ( o ) d o L a L C ) o . l o l L D n C i L u uF)² V ll (VD ) nt F nt M ad ( t No rent Fu ge ( e e e o n a % r r g t ( L r r l e a r u u r y r lt or Vo C C t Vo t Cu put Cu ienc a c it pu t pu t pu t In p u In p u In O ut Out O ut Effic Ca p 3.96 5 6 6 3.96 5 6 6 9 - 36 9 - 36 9 - 36 9 - 36 18 - 72 18 - 72 18 - 72 18 - 72 12 18 15 18 10 15 10 10 220 260 301 301 109 130 151 149 3.3 5 12 15 3.3 5 12 15 0 0 0 0 0 0 0 0 1200 1000 500 400 1200 1000 500 400 75 80 83 83 76 80 83 84 1000 680 1000 470 1000 680 1000 100 5 6 6 5 6 6 9 - 36 9 - 36 9 - 36 18 - 72 18 - 72 18 - 72 18 20 22 15 10 15 260 301 309 130 152 149 ±5 ± 12 ± 15 ±5 ± 12 ± 15 0 0 0 0 0 0 ± 500 ± 250 ± 200 ± 500 ± 250 ± 200 80 83 82 80 82 84 ± 330 ± 330 ± 100 ± 330 ± 100 ± 47 If you need other specifications, please enquire. PEN5-Series – PEN5-xxxxE/Z4:1MLF – Single and Dual Output – DIP24 - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 2/3 Package / Pinning / Derating 27.94 (1.10) 1 All dimensions are typical in millimeters (inches). - Pin diameter: 0.5 +/-0.05 (0.02 +/-0.002) - Pin pitch tolerance: +/-0.35 (+/-0.014) - Case tolerance +/-0.5 (+/-0.02) Standard Drawing For exact pinning please see connection table! Specification may change without notice. 12 Bottom View 24 13 2.54 (0.10) DIP24 – METAL CASE 2.00 (0.08) 10.16 (0.40) PEAK Modelcode Datecode 31.75 (1.25) 3.05 (0.12) PIN CONNECTIONS # SINGLE DUAL 2 - Vin - Vin 3 - Vin - Vin 9 Omitted Common 11 N.C. - Vout 14 +Vout +Vout 16 - Vout Common 22 +Vin +Vin 23 +Vin +Vin others Omitted Omitted App Notes: ¹ = Measured Input reflected ripple current with a simulated source inductance of 12uH. ² = Tested by nominal Vin and constant resistive load. 3 = It’s recommended to add C1(68mF), C2(33mF), L(12mH) in input end to achieve EN55022 conducted Class A. EMC SPECIFICATIONS Radiated Emissions Conducted 3 Emissions ESD RS EFT CS PFMF EN 55022 CLASS A EN 55022 CLASS A IEC 61000-4-2 IEC 61000-4-3 IEC 61000-4-4 IEC 61000-4-6 IEC 61000-4-8 Perf. Criteria B Perf. Criteria A Perf. Criteria B Perf. Criteria A Perf. Criteria A PEN5-Series – PEN5-xxxxE/Z4:1MLF – Single and Dual Output – DIP24 - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 3/3